Important Safety Instructions - Thermador MES301HS Installation Manual

Safety
A Important Safety Instructions
READ AND SAVE THESE INSTRUCTIONS
Appliance Handling Safety
Safety Codes and Standards
Electric Safety
READ AND SAVE THESE INSTRUCTIONS
WARNING: [f the information in this manual is not followed exactly, fire or
shock may result, causing property damage or personal injury.
WARNING: Do not repair or replace any part of the appliance unless
specifically recommended in the manuals. Improper installation, service or
maintenance can cause injury or property damage. Refer to this manual for
guidance. All other servicing should be cone by a qualified technician.
Do not lift appliance by door handle. See instructions in Instruction Manual.
The appliance is heavy and requires at least two people or proper equipment to
move,
Hidden surfaces may have sharo edges. Use caution when reaching behind or
under the appliance.
This appliance complies with one or more of the following standards:
« UL 1026, Standard for Safety Electric Household Cooking and Food Serving
Appliances
@ CAN/CSA-C22.2 No. 64-M91 Household Cooking Ranges
it is the responsibility of the owner and the installer to determine if additional
requirements and/or standards apply to specific installations.
Before you connect the electrical cord to the conduit box, be sure all controls are in
the OFF position.
if required by the National Electrical Code (or Canadian Electrical Code}, this
appliance must be installed on a separate branch circuit.
Installer - Show the owner the location of the circuit breaker or fuse. Label it for
easy reference.
Important - Save these instructions for the local electrical inspector's use.
Before installing, turn power OFF at the service panel. Lock service panel to prevent
power from being turned ON accidentally.
Refer to data plate for more information. See "Data Plate" under "Service" for data
plate location.
This appliance must be properly installed and grounded by a qualified technician.
installation, electrical connections and grounding must comply with all applicable
codes.