Sony KP-53XBR45 Operating Instructions Manual page 16

PO a ee i
Adjusting convergence
(CONVERGENCE)
The projection tube image appears on the screen in
three layers (red, green and blue). If they do not
converge, the color is poor and the picture blurs. To
correct this, adjust convergence.
1 Press MENU.
2 Press the joystick up or down to move the
cursor () to SET UP and click the joystick.
3 Press the joystick up or down to move the
cursor (@) to CONVERGENCE and click the
joystick.
The CONVERGENCE adjustment screen appears.
ODA x7 DADA
G=green
R=red
B=blue
4 Press the joystick up or down to move the
cursor (&) to RED or BLUE, and click the
joystick.
DOD WHAD
5 press the joystick up, down, left or right to
move the line until it converges with the
center green line, and click the joystick.
G+R.
B eee
G+R
B
6 Repeat steps 4 and 5 to adjust the other
lines until all three lines converge and are
seen as a white cross.
7 Press MENU to return to the original screen.
Note
¢ Convergence can be adjusted only left, right, up and down.
16 EN | Getting Started
I Nt ee 55 |
Setting cable TV on or off
If vou have connected the projection TV to a cable TV
system, set CABLE to ON, the factory setting. If not, set
CABLE to OFF. You do not have to do this procedure
if you execute AUTO SET UP (page 14). Do this
procedure only when you want to set it manually.
1 Press MENU.
2 Press the joystick up or down to move the
cursor (&) to SET UP and click the joystick.
3 Press the jeystick up or down to move the
cursor (@) to CABLE and click the joystick.
@ CABLE; RION
(err
=
Use @ RETURN@ Exit GU)
4 Press the joystick up or down to select ON
or OFF and click the joystick.
@ CHANNEL ERASE/ADD
620) } CHANNEL CAPTION/LOGO
EI FAVORITE CHANNEL
| | CONVERGENCE
DIRECT PLAY
FF
TV INPUT: 0
A CABLE : OFF
i] AUTO PROGRAM
{ CUSTOMIZED POINTER
ae) ES LANGUAGE : ENGLISH
2
Use @) RETURN Exit
5 press MENU to return to the Original screen.
Note
¢ If CABLE appears in grey, the projection TV is set to a video
input and you cannot select CABLE. Press TV/VIDEO on the
remote commander so that a channel number appears.