Sony KP-53XBR45 Operating Instructions Manual page 44

Operating non-
preprogrammed
equipment —
Learning function
You can program the supplied remote commander to
learn the functions of another remote commander. Use
this function to operate equipment whose
manufacturer's code is not preprogrammed, such as
Sony or other manufacturers' audio equipment or other
eqitipment whose manufacturer's code is not listed on
pages 40 - 42.
QOD0O00O :
VTR1 2 3 MDP > OOo
selector D@QO@o
COQQe®
i=) fas kes)||
= LEARN
LEARN indicator
(with the lid open)
1 Set the VTR1 2 3 MDP selector to VTR3 or
mIpr: VTR1 2 3MDP
eo000
C CI)
al
2 Place the supplied remote commander and
the other equipment's remote commander
directly facing each other, approximately
5 cm (2 inches) apart.
Other equipment's
remote commander
Approx. 5 cm
(2 inches) SS
RM-Y128
Supplied remote
commander
3 Press and release the LEARN button.
The LEARN indicator lights up.
LEARN
O
When the LEARN indicator flashes off and then on
again, this indicates that learning is complete. If
not, repeat steps 4 and 5.
6 Repeat steps 4 and 5 to learn other
functions.
7 Press LEARN.
The LEARN indicator goes off, indicating that
learning is complete.
Notes
¢ The LEARNING function does not work in VTR1 or VTR2
setting.
* Do not move the remote commanders during learning.
¢ To clear all learned signals from memory, set the VTR1 23
MDP selector to MDP, press LEARN, then press TV POWER
while holding down VOL -. Then press LEARN again.
Caution
e Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code numbers revert
to the factory settings and must be reset.
Operations | 43-EN