Packaging:Thanks for your purchasing the AH042A. All the lights have been checked Mechanical Specification and are in excellent operating condition. Please check the shipping carton first,because there may be damage occurred during the shipment.Then check the lights carefully and be sure that the lights is intact and works normally.In the event damage has been found, spare parts are missing or the lights works abnormally,please contact us for further instructions.
Page 3
Features Product Overview ● Light Source: 18*20W, 4 in 1 RGBW LEDs 349.94 ● Lens: 8° ● Power consumption: 350W ● Voltage: AC 90V -240V, 50/60Hz ● Run Mode: DMX 512 /Master Slave/Auto Run ● 10 internal programs and 11 customerize programs ●...
Mounting Programme Menu When installing the unit, the trussing or area of installation must be able to ADDRESS hold 10 times the weight without any deformation. When installing the unit DMX Address must be secured with a secondary safety attach-ment, e.g. and appropriate ADDRESS safety cable.
Slave Mode Slave CABLE CONNECTORS Custom Mode Custom Mode Custom Mode Cabling must have a male XLR connector on one end and a female XLR connector on the other end. Green DMX connector configuration Blue White PR-01 Fade SC-01 GROUND Edit Mode Flash SC-32...
Displayer introduction ① ② ③ temp:043 ④ ADDRESS Key lock open ⑤ 1. DMX means the light is in the DMX mode.Similarly,SLAVE means the light is in the SLAVE mode. 2. The color of the point shows the condition of signal transmission. Green represents the good condition, while red represents the signal is interrupted.
Connection DMX Address-In this menu, you can select the DMX Address. 1. Press “ENTER” button and then UP or DOWN button until “DMX Address ” is showed. 2. Press “ENTER” button, and “DMX Address” will be showed. Then press ENTER. 1) “xxx”...
Page 8
2. Press “ENTER” button, and open the “EDIT” mode to edit the custom programs from“PR.01” to “PR.11”.And there are 32 scenes that can be edited in each custom program. DMX 11 channel 3. You can edit a scene by adjusting the value of “RED (0~255)”, “GREEN (0~255)”, “BLUE (0~255)”, channel value function...
DMX control mode DMX 3 channel channel value function 0 - 255 0 - 255 Saturation 0 - 255 Value(brightness) DMX 4 channel channel value function 0 - 255 Adjust red LEDs Dimmer from low to high 0 - 255 Adjust green LEDs Dimmer from low to high 0 - 255 Adjust blue LEDs Dimmer from low to high...
Page 10
DMX 8 channel channel value function 0 - 255 0 = Off 1 - 255 = Master dimmer Adjust red LEDs Dimmer from low to high 0 - 255 Adjust green LEDs Dimmer from low to high 0 - 255 Adjust blue LEDs Dimmer from low to high 0 - 255 0 - 255...
Page 11
156 - 159 chocolate 160 - 163 just blue 164 - 167 surprise pink scarlet 168 - 171 surprise peach 172 - 175 fire 176 - 179 180 - 183 english rose 184 - 187 mauve 188 - 191 bright blue 192 - 195 alice blue 196 - 199...
Page 12
DMX 11 channel channel value function 0 - 255 0 = Off 1 - 255 = Master dimmer Adjust red LEDs Dimmer from low to high 0 - 255 Adjust green LEDs Dimmer from low to high 0 - 255 0 - 255 Adjust blue LEDs Dimmer from low to high 0 - 255...
Page 13
DMX control mode Default 0 - 9 DMX 3 channel 10 - 255 strobe(0Hz - 20Hz) channel value function 0 - 7 Default 0 - 255 8 - 17 Auto 1 0 - 255 Saturation Auto 2 18 - 37 0 - 255 Value(brightness) 38 - 57...
Page 15
Connection DMX Address-In this menu, you can select the DMX Address. 1. Press “ENTER” button and then UP or DOWN button until “DMX Address ” is showed. 2. Press “ENTER” button, and “DMX Address” will be showed. Then press ENTER. 1) “xxx”...
Page 16
Mounting When installing the unit, the trussing or area of installation must be able to hold 10 times the weight without any deformation. When installing the unit must be secured with a secondary safety attach-ment, e.g. and appropriate safety cable. Never stand directly below the unit when mounting, removing, or servicing the unit.
Page 17
Slave Mode Slave CABLE CONNECTORS Custom Mode Custom Mode Custom Mode Cabling must have a male XLR connector on one end and a female XLR connector on the other end. Green DMX connector configuration Blue White PR-01 Fade SC-01 GROUND Edit Mode Flash SC-32...