Installation
①
Decompose drown rod and remove the screws which are used to install the blades.
②
Route all the wires from the motor the
down rod through. Fix the down rod to the
coupling with bolt,and then insert the
clevis pin.Last tighten the two screws on
coupling.
Bolt
Coupling
Clevis Pin
Step 1 (Basic assembly of the fan)
Visit www.pmwfan.com
③
Assemble the canopy,coupling cover,and
hanging ball through the down rod.Then
insert the fixing pin, push the hanging ball
up, and fix it with screws.
.6.
for further assistance.
x 9
Remove the screws
Tighten the two screws