Table of Contents
Advertisement
Remote Control Operation
Transmitter learning
process
1.Insert the 2 pcs of batteries into transmitter.
2.Turn on the power supply to the fan. Within 10 sec, press
and hold the "1" and "2" button for about 3 sec. Once the
receiver has detected the frequency, receiver will "Beep
Beep" twice.Programming process is completed and fan is
ready to use.
NOTE: The remote control device has already been code matching
when it leaves the factory.If the fan is not responding to the transmit-
ter,repeat transmitter learning process.
ABOUT THE MEMORY FUNCTION OF LIGHTS：Please wait for more
than 3-5 seconds keep this color that you need at first, and then turn off
wait for at least 10 seconds turn on again. This light color would be
your need.
IMPORTANT: The fan can only operate normally after all blades are
installed. If the fan is turned on without installing the blades, the receiver
will detect that the fan speed is too fast and the fan will automatically stop.
Remote Control Holder
Installation
①
AAA 1.5V
③
⑤
②
④
⑥
Visit www.pmwfan.com
Press and hold
for about 3 sec
Transmitter Function
3
2
1
6
-
1H
6H
.10.
for further assistance.
4
Fan Off
5
Fan Speed
(1/2/3/4/5/6)
Forward/Reverse
LED On/Off
Colour Change
+
Light brightness "+/-"
3H
Fan Timer Switch
(1hr,3hr,6hr)
Advertisement
Table of Contents
