Table of Contents
Advertisement
Setup/Startup
14. Set pump switch to ON (pump is now active).
15. Increase pressure control enough to start pump.
Allow fluid to circulate for 15 seconds.
16. Turn pressure down, turn prime valve horizontal.
Disengage gun trigger lock.
17. Hold all guns against a grounded metal flushing pail.
Trigger guns and increase fluid pressure slowly until
pumps run smoothly.
High-pressure spray is able to inject toxins into the
body and cause serious bodily injury. Do not stop
leaks with hand or rag.
14
18. Inspect fittings for leaks. If leaks occur, turn sprayer
19. Place siphon tube in paint pails.
ti28017a
20. Trigger all guns again into a flushing fluid pail until
15s
ti28016a
SwitchTip and Guard Assembly
1. Engage trigger lock. Use end of SwitchTip to press
ti28018a
2. Insert SwitchTip in tip bore and firmly thread assem-
ti28019a
OFF immediately. Perform Pressure Relief Proce-
dure. Tighten leaky fittings. Repeat Startup, steps
1 - 17. If no leaks, continue to trigger gun until sys-
tem is thoroughly flushed. Proceed to step 18.
ti27613a
paint appears. Assemble tips and guards.
OneSeal into tip guard, with curve matching tip
bore.
bly onto gun.
ti27774a
ti27775a
ti27776a
3A3426A Operation
Advertisement
Table of Contents
