LG WD-3243RHD Owner's Manual page 20

÷ Before cleaning the washer interior, unplug the electrical power cord to avoid electrical
shock to avoid electrical shock hazards.
• The water inlet filter
- No Inlet error message will blink on the control panel when water does not enter the
detergent drawer.
- If your water is very hard or contains traces of lime deposit, the water inlet filter may
become clogged.
It is a good idea to clean it from time to time.
1, Turn off the
water tap.
3, Clean the
filter using a
hard bristle
brush.
2. Unscrew the
waterinlet
hose.
4. Tighten up
theinlet
hose.
• The drain pump filter
÷ Thedrainfiltercollectsthreadsandsmallobjectsleft in thelaundry.
Checkregularly thatthe filteriscleanto ensuresmoothrunning of yourmachine.
_, CAUTION Firstdrain it usingthe drain hoseand thenopen the pumpfilter to remove
whatever may havestopped it up.
Be carefulwhendraining if thewater is hot.
1. Open the lower cover
cap IN by using coin.
Turn the drain plug/_
to pullout the hose.
2. Unplugthe drain plug _, allowing
the water to flow out. At thistime
use a vessel to preventwater
flowing on to the floor. If the water
doesnot flow any more, turn the
pump filter _ open to the left.
3. Take out any foreignmaterial
from the pump filter _. After
cleaning, turn the pump filter _
clockwiseand insert the drain
plug _to the original place,
close the lower cover cap.