Warnings And Cautions; Wa R N I N G S A N D C A U T I O N S - Conair LDP-5 User Manual

5 - 2 l M a i n t e n a n c e

Wa r n i n g s a n d C a u t i o n s

To maintain the best performance of the LDP, it must be cleaned and inspected regularly.
Maintenance includes a daily, weekly, quarterly, and semi-annual (every 6 months) sched-
ule.
✐
NOTE: Maintenance intervals depend a great deal on the specific operating conditions of your operation
and your conveying system. The following intervals should only be considered a starting reference which
can be shortened or extended as appropriate. Particularly heavy operation, with high dust content loading
(IE: powder conveying) can make it necessary to shorten the maintenance intervals significantly.
During any maintenance procedure, make sure that the pump is shut down and locked out
against in-advertent start up.
CAUTION: During operation, the surface of the pump may reach temperatures exceeding
158°F {70 °C}. Be aware of the risk of burns!
WA R N I N G : Vo l t a g e h a z a r d
This equipment is powered by alternating current, as specified on the machine
serial tag and data plate. Do not operate the equipment at power levels other
than what is specified on the machine serial tag and data plate.
A properly sized conductive ground wire from the incoming power supply must
be connected to the chassis ground terminal inside the electrical enclosure.
Improper grounding can result in severe personal injury and erratic machine
operation.
Before performing maintenance or repairs on this product, disconnect and lock
out electrical power sources to prevent injury from unexpected energization or
start-up. A lockable device has been provided to isolate this product from poten-
tially hazardous electricity.
WA R N I N G : I m p r o p e r I n s t a l l a t i o n , o p e r a t i o n , o r s e r v -
i c i n g m a y r e s u l t i n e q u i p m e n t d a m a g e o r p e r s o n a l
i n j u r y.
This equipment should only be installed, adjusted, and serviced by qualified technical
personnel who are familiar with the construction, operation, and potential hazards of this
type of machine.
All wiring, disconnects, and fuses should be installed by qualified electrical technicians in
accordance with electrical codes in your region. Always maintain a safe ground. Do not
operate the equipment at power levels other than what is specified on the machine serial
tag and data plate.