Table of Contents
Advertisement
INSTALLATION
10
INSTALLATION
Before Installation
Notes for Installation
• Do not lean the appliance more than 30°. Doing
so can cause malfunctions.
• Keep a distance of 10 cm from front and sides of
the product.
• A cold water supply with water pressure
between 0.01 MPa and 0.86 MPa (0.1-8.8 kgf/
cm²) is required to operate this appliance.
• If you do not use the appliance for a while due to
moving, etc., store it in an environment where
water does not freeze.
- The appliance may malfunction due to
freezing.
• Install on a hard and level floor/wall.
- If the floor/wall of the installation site is
uneven, vibration or noise may occur, and the
appliance may fall over and cause injury.
• Places where installation should be avoided for
hygienic management of water purifiers and
prevention of condensation.
- Outdoors or in direct sunlight
- A place close to the toilet
- In front of air conditioner/heater
- Other places with high humidity or
temperature
• Height between immediate water reservoir tank
to water purifier inlet should be more than 1
meter for effective working of the product.
• For optimum performance of product,
installation condition should be
TDS, hardness
1
425 mg/L and turbidity
NOTE
• All models can only be installed with water
supply from overhead storage tank. No other
water supply should be used for installation of
these models.
Ambient Temperature
• The appliance is designed to operate within a
Turning on the Power
Connecting the Appliance
After installing the appliance, connect the power
plug into the outlet socket.
NOTE
• Before moving and discarding the appliance,
Final Installation Check
Testing the Appliance
1
2
1
2000 mg/L
1
5 NTU.
NOTE
• Do not connect the water supply pipe of the
limited range of ambient temperatures,
depending on the climate zone.
Install the appliance inside with a surrounding
temperature of over 5
disconnect the plug from the socket outlet.
Make sure that hoses are connected properly.
After installation, discharge water for the first
time when water tank is full. Same process is to
be followed after every filter change or digital
sterilization. Appropriate time taken to fill the
tank to the fullest is 1 hour, depending on
water pressure, temperature, etc.
• Water may remain inside the water filtration
system due to the inspection process carried
out while manufacturing the appliance.
appliance to the hot water pipe, and connect it
only to the cold water pipe.
and less than 43
7
7
.
Advertisement
Table of Contents
