Table of Contents
Advertisement
INSTALLATION
Before Installation
Notes for Installation
• Do not lean the appliance more than 30°. Doing
so can cause malfunctions.
• Keep about 10 cm of clearance from the wall on
the back and both sides for proper ventilation.
Failure to do so can cause malfunctions.
- If the distance between the appliance and the
wall is too close, the air may not pass through,
so dew may form on the surface of the
appliance and the electricity bill may be high.
• A cold water supply with water pressure
between 147 kPa and 780 kPa (1.5-7.9 kgf/cm²) is
required to operate this appliance.
• When the water pressure is low, the volume of
water supply may be small.
• If you do not use the appliance for a while due to
moving, etc., store it in an environment where
water does not freeze.
- The appliance may malfunction due to
freezing.
• Install on a hard and level floor.
- If the floor of the installation site is uneven,
vibration or noise may occur, and the
appliance may fall over and cause injury.
• Places where installation should be avoided for
hygienic management of water purifiers and
prevention of condensation.
- Outdoors or in direct sunlight
- A place close to the toilet
- In front of air conditioner/heater
- Other places with high humidity or
temperature
• Do not install or use the appliance in a place that
uses groundwater.
Ambient Temperature
• The appliance is designed to operate within a
limited range of ambient temperatures,
depending on the climate zone.
Install the appliance inside with a surrounding
temperature of over 5 °C and less than 35 °C.
Turning on the Power
Connecting the Appliance
After installing the appliance, connect the power
plug into the outlet socket.
NOTE
• Before moving and discarding the appliance,
disconnect the plug from the socket outlet.
Final Installation Check
Testing the Appliance
1
Make sure that hoses are connected properly.
2
Dispense over 1000 ml water from the cold and
ambient temperature water tap respectively
and 120 ml water from the hot temperature
water tap 4 times.
• Water may remain inside the water filtration
system due to the inspection process carried
out while manufacturing the appliance.
3
Wait for the water to cool.
NOTE
• Do not connect the water supply pipe of the
appliance to the hot water pipe, and connect it
only to the cold water pipe.
INSTALLATION
9
Advertisement
Table of Contents
