Related Manuals for Norden Mfg SSB-72US
Summary of Contents for Norden Mfg SSB-72US
- Page 1 Owner Manual Skid Steer Buckets SSB-72US SSB-78LL SSB-84US Read, Understand, and Follow this manual which provides information MADE IN THE USA and procedures to safely operate and maintain the attachment.
-
Page 3: Table Of Contents
2.3.2 Prohibited Actions ....7 10.4 SSB-72US Parts Detail ....28 2.3.3 Hazard Avoidance . -
Page 4: Introduction
Overall Approximate Weight 617 lb. mentioned throughout this manual, are as seen from 3/4” x 6” x 80” Bolt On Cutting Edge Size the operator’s seat, facing in the direction of travel. 4-6(12)-4 Approx. Struck Capacity 16.4 Cu. Ft. Norden Mfg. LLC (877) 296-5851 Skid Steer Loader Buckets... -
Page 5: Ssb-84Us Specifications
1.6 Disposal of Equipment at End of Useful requesting service, seeking information, or ordering Life parts. The Norden Mfg LLC loader buckets are designed for the specific purpose of moving gravel and dirt. 4210 Kinsman Rd NW, North Bloom eld, OH 44450 www.nordenmfg.com - (877) 296-5851 When this loader bucket is no longer capable of Approx. -
Page 6: Safety
MAY result in minor or to you or to other persons. moderate injury. Norden Mfg LLC cannot anticipate every possible NOTICE circumstance that might involve a potential hazard. The warnings in this manual and on the product are, Indicates that loader bucket or property damage therefore, not all-inclusive. -
Page 7: Safety Icons Nomenclature
STOP Not a lifting device Visibility - slow moving vehicle (SMV) Electrocution hazard Set parking brake Entanglement hazard 2.3.2 Prohibited Actions Do not alter or modify Do not leave out tools Skid Steer Loader Buckets Norden Mfg. LLC (877) 296-5851... -
Page 8: General Safety
Consult your doctor before using the loader bucket while taking prescription 2.11 Training medications. Norden Mfg LLC follows the general Safety Falling Hazard Standards specified by the Farm Equipment Do not allow riders on the machine Manufacturers Association (F.E.M.A.), and the or attachment at any time. Falling can result in American National Standards Institute (ANSI). -
Page 9: Authorization / Training Sign-Off Form
OEM machine manuals, and the safety decals. If you do not understand any information in this manual, see your dealer or contact Norden Mfg LLC before proceeding. Do not use or allow anyone else to use this attachment until all information has been reviewed. - Page 10 Authorization / Training Sign-Off Form Date User’s Signature Owner’s Signature Norden Mfg. LLC (877) 296-5851 Skid Steer Loader Buckets...
-
Page 11: Safety Decals And Labels
5. Replacement parts must have replacement decals attached before the attachment is used. 6. Decals are available from your authorized dealer or from Norden Mfg LLC at no charge. Skid Steer Loader Buckets Norden Mfg. LLC (877) 296-5851... -
Page 12: Safety Decal Locations
Coupler Handles - Locked 3.4 Safety Decals Handle Lockpins must completely Locked engage attachment plate slots. Lockpin Extended 1027140 WARNING — Pin Engagement INFORMATIONAL — Read the Manual WARNING — No Riders Norden Mfg. LLC (877) 296-5851 Skid Steer Loader Buckets... -
Page 13: Nomenclature
4. Nomenclature Item Description Loader Bucket Bolt-on Cutting Edge Plow Bolt and Nut Attachment Plate Top Lip Attachment Plate Slots Skid Steer Loader Buckets Norden Mfg. LLC (877) 296-5851... -
Page 14: Assembly And Setup
For light-weight tractors or specific skid steer loaders, consult the Skid Steer or Tractor Operator’s Manual to determine if rear ballast is required for heavy loads to maintain steering control. Norden Mfg. LLC (877) 296-5851 Skid Steer Loader Buckets... -
Page 15: Usage
This section is provided to give the operator general safety information for the machine. Always follow the Never allow children to use the attachment. OEM instructions given in the operator’s manual for the machine. Skid Steer Loader Buckets Norden Mfg. LLC (877) 296-5851... -
Page 16: Attaching To Machine
The lock pins should fully extend through the bottom slots in 4. Raise and curl the loader coupler until the the attachment hitch plate. attachment lifts and the back surface of the Norden Mfg. LLC (877) 296-5851 Skid Steer Loader Buckets... -
Page 17: Pre-Operation Checklist
NOTICE Care must be taken to ensure there is enough overhead clearance and no potential hazards or obstructions that could interfere with the lifting and placing of the loads. Skid Steer Loader Buckets Norden Mfg. LLC (877) 296-5851... - Page 18 4. Slowly drive into the pile without ramming the bucket. NOTICE WARNING No Chains. Bystander Hazard Do not attach chains intended for lifting or securing loads to the loader bucket, as it may cause damage. Norden Mfg. LLC (877) 296-5851 Skid Steer Loader Buckets...
-
Page 19: Moving With A Load
Steps 3, 4, and 5. 15. Keep equipment away from electrical power 3. Shutdown the machine properly without lowering lines and place orange warning signs under the loader bucket. Skid Steer Loader Buckets Norden Mfg. LLC (877) 296-5851... - Page 20 7. Slowly lower the loader bucket to the ground, allowing the top lip and loader hitch to separate. 8. Gradually reverse the machine, ensuring that the loader hitch does not interfere with the loader bucket. Norden Mfg. LLC (877) 296-5851 Skid Steer Loader Buckets...
-
Page 21: Transporting
Plan your route to avoid heavy traffic. Travel on roadways in such a way that faster moving vehicles can pass safely. Skid Steer Loader Buckets Norden Mfg. LLC (877) 296-5851... -
Page 22: Contents 8. Storage
8.2 Removing from Storage 1. Attach the loader bucket to the machine following the procedure in section “6.3 Attaching to Machine” on page 16. 2. Before placing the loader bucket back into service, replace any worn or defective parts and perform the “6.4 Pre-Operation Checklist” on page 17. Norden Mfg. LLC (877) 296-5851 Skid Steer Loader Buckets... -
Page 23: Maintenance
Crush Hazard bucket life and is an invitation for problems. Always set the loader bucket on blocks Norden Mfg LLC will not claim responsibility for use or on the ground when performing of unapproved parts and/or accessories and other maintenance. -
Page 24: Bolt Torque Requirements
9.5.2 Remove Bolt-on Cutting Edge. Before performing any type of welding repair 1. It is recommended to use new plow bolts. The to the loader bucket, contact Norden Mfg old bolts can be recycled. Norden Mfg. LLC (877) 296-5851 Skid Steer Loader Buckets... -
Page 25: Install The Bolt-On Cutting Edge
Lift one end of the blade and tilt it up until the bolt fits through. Loosely fasten the nut, then rotate the blade to be parallel to the front of the bucket. 2. Install all bolts and finger tighten the nuts. An alignment tool may be used to correct alignment. Skid Steer Loader Buckets Norden Mfg. LLC (877) 296-5851... -
Page 26: Service Record
Annually Make sure all fasteners are tightened to proper torque. Refer to “9.3 Bolt Torque Requirements” on page 24. Inspect and replace damaged safety decals or instructional labels. Wash the loader bucket. Inspect attachment frame for cracking or damage. Norden Mfg. LLC (877) 296-5851 Skid Steer Loader Buckets... -
Page 27: Parts Section
10. Parts Section 10.1 Ordering Parts Norden Mfg LLC manufactures a quality product that requires very little maintenance or repair. However, should a part break or become damaged, our knowledgeable staff can make sure you receive the part(s) to put your loader bucket back into operation. 10.2 Contact Information... -
Page 28: Ssb-72Us Parts Detail
10.4 SSB-72US Parts Detail x 12 x 12 Finish Item Quantity Part number Name 1029710 SSB Weldment Black 1027150 Bolt-On Cutting Edge, 74”, 4-6(11)-4 Black 1029370 Plow Bolt, #3 Domed Head, 5/8”-11 x 2” Grade 8 Zinc 1029380 5/8”-11 Grade 8 Flange Hex Nut Zinc 1027460 1027460 Data Plate 1027180 Decal - Manufacturing Small 1024330 Decal - Read Manual... -
Page 29: Ssb-78Ll Parts Detail
Decal - Manufacturing Small 1024330 Decal - Read Manual 1028630 Decal - Warning No Riders 1028650 Decal - Falling Hazard horizontal 1014760 Norden Logo 1" 1027140 Decal - SS Lock Warning 1027400 Norden Logo 1.375" Skid Steer Loader Buckets Norden Mfg. LLC (877) 296-5851... -
Page 30: Ssb-84Us Parts Detail
Decal - Manufacturing Small 1024330 Decal - Read Manual 1028630 Decal - Warning No Riders 1028650 Decal - Falling Hazard horizontal 1014760 Norden Logo 1" 1027140 Decal - SS Lock Warning 1027400 Norden Logo 1.375" Norden Mfg. LLC (877) 296-5851 Skid Steer Loader Buckets... - Page 31 Skid Steer Loader Buckets Norden Mfg. LLC (877) 296-5851...
- Page 32 Norden Mfg LLC 4210 Kinsman Rd NW North Bloomfield, OH 44450 www.nordenmfg.com (877) 296-5851 support@nordenmfg.com 1029100 Rev. A Revised 06-2023...