Advertisement
Chapter Objectives
Connecting a
Personal Computer
Downloading Configurations
This chapter describes how to download a configuration between the
Reader and a personal computer running the AdaptaScan software.
Section
Connecting a Personal Computer
Downloading Firmware
Downloading a Configuration
AdaptaScan Bar Code Reader configurations and firmware are
downloaded:
directly through the Configuration Port Connector on the Reader
through any Reader on the same DeviceNet or RS-485 network
Remove the protective cap from the Reader's Configuration Port
Connector. Use the Configuration Cable (Catalog No. 2755-NC48)
to connect the computer to a Reader. One cable end connects to the
Configuration Port Connector on the Reader. Connect the end with
the 9-pin D shell connector to the computer's serial port. You may
need a 9-to-25 pin adapter if your computer has a 25-pin serial port.
Note: The Series A Reader uses the 2755-NC43 programming
cable. This cable is not compatible with the Series B Reader.
ATTENTION: Do not extend the length of the
Configuration Cable (Catalog 2755-NC48). This
!
unshielded cable cannot exceed a length of 3 meters or
9 feet, 10 inches.
Note: Configure the computer port and address for download using
Preferences dialog in the AdaptaScan Software.
5
Chapter
Page
5–1
5–3
5–4
Advertisement
