Table of Contents
Advertisement
Installation of the Magellan RoadMate receiver is simple and easy. The hardest part will be picking the best
location.
Selecting the Location
A few tips on selecting the proper location.
•
Mount the Magellan RoadMate receiver in a place where it can be easily seen and will not interfere with
your view of the road.
•
The Magellan RoadMate receiver should be mounted in such a way that the antenna, (located in the top of
the receiver), has an unobstructed view of the sky through the windshield.
•
Make sure that the Magellan RoadMate receiver or any cabling will not be disturbed if the airbags are
activated.
•
Be sure to check your local and regional laws before mounting to the windshield. Some states have laws
restricting the mounting of any device on the windshield.
Securing the Car Cradle
Clean the area on the windshield that has been selected for mounting the Magellan RoadMate receiver. Let the
area dry completely.
Make sure that the lever at the base of the adjustable mount is in the up position. Place the base of the car cradle
firmly over the area where it will be placed. Push the lever at the base of the swivel mount all the way down until
it snaps in place. Carefully let go of the assembly, making sure that it is securely mounted.
(The Car Cradle shown here may be different from the Car Cradle supplied with your Magellan RoadMate
receiver, but the installation is the same for all cradle styles.)
Attaching the Magellan RoadMate receiver to
the Car Cradle
Slide the Magellan RoadMate receiver on the car cradle so
that the slot on the Magellan RoadMate receiver aligns with
the tab on the car cradle. Slide the Magellan RoadMate
receiver all the way down until it rests on the 'feet'. You should
notice a click when the receiver is fully mounted in the cradle.
Adjusting the Mount for Optimum Viewing
Loosen the adjustment locking knob and position the Magellan RoadMate receiver for optimum viewing. Once
set, tighten the locking knobs. (Never attempt to adjust the mount while driving.)
Connecting Power
Plug the end of the vehicle power adapter into a 12VDC vehicle power receptacle. Connect the other end of the
cable to the Magellan RoadMate receiver's power connector as shown.
Note: Some vehicles apply power to the vehicle power receptacle only when the ignition is on.
Checking Connection and Final Adjustments
If the power indicator light on the vehicle power adapter is on, power is being supplied to the Magellan RoadMate
receiver. If it is not on, check the cable connection to the vehicle power receptacle. If the light is still not on, turn
the vehicle's ignition on.
Installation Instructions
8
Advertisement
Table of Contents
