Advertisement
Home theater
You can enjoy the 5.1-channel surround sound found on DVD recorded with Dolby Digital or DTS Digital Surround by connecting an amplifier with
a built-in decoder or a separate decoder-amplifier
combination.
Beck of the unit
Nots when connecting
the optical digital audio cable
_ection
cap _Align
the plug with the
terminal
• Remove the dust protection cap from the optical digital audio
output terminal and connect the cable firmly so that the
configurations of both the cable and the terminal match.
eKeep the dust protection cap and reattach when not using the
terminal.
|
I
f
I
I
D
Optical digital audio cable
eDo not band the optical digital audio cable when connecting it.
Coaxial audio cable
Amplifier with a built-in decoder
eRead the instructions for the amplifier and speakers for connection
details.
Speakers
(You can connect from 3 to 5 speakers including the front two.)
eFront speakers (L/R)
eCenter speaker
eSurround speakers (L/R)
eSubwoofer
When you have finished connection
Make changes to "7 Digital Audio Output" to suit your decoder (=Jpage 36).
Dolby Digital/
Decoder
DTS Digital Surround
DTS Digital Surround
Dctby Digital decoder
decoder
decoder
PCM Down Conversion
Yes ÷
Yes _
Yes _
Dolby Digital
Bitstream
PCM
Bitstream
DTS Digital Surround
Off
Bitstream
Bitstream
If this is set to "No", no audio will be output when DVDs recorded in 96 kHz linear PCM are played. (Audio will be output as it is if the DVD does not
have copyright protection recorded on it.)
eThese changes to digital audio output must be made, otherwise bitstream
signals the decoder cannot handle will be output. If these
signals are output, "noise"
will be output which can cause harm to your ears and speakers.
• You cannot use DTS Digital Surround decoders not suited to DVD.
Advertisement
