Panasonic Omnivision PV-V4640 Operating Instructions Manual page 5

1 Between ANT. and VCR 2 Between VCR and TV
E Case 1: Twin Lead Cable Only E Case 1: Screw & Plug Type Terminal
To VCR Terminal UHF/VHF Band
Separator
udlps 31seg
E Case 2: Screw Type Terminal
E Case 2: Twin Lead & Coaxial Cables
75-300 ohm
Transformer
(not supplied)
UHF/VHF Band Mixer
(not supplied)
(Round) 75 Ohm UHF/VHF Band
coaxial Cable Separator
To VCR Terminal (not supplied)
E Case 3: Two Twin Lead Cables
=e E Case 4: Complex TV Terminal
UHF/VHF Band Mixer TERMINALS ON BACK OF TV SET
(not supplied)
Split out
300-75 ohm .
Transformer ANTI
(not supplied)
To VCR Termina!
+ if your TV has both post and plug-type
VHF terminals, the post connection is
recommended to minimize signal loss. * Connect to one of the ANT terminals and
select the same antenna number on the TV.
Note to CARLE system — ore ae FCC Waming: Any unauthorized changes or modifications
This reminder is provided to call the system installers to this equipment would void users a ri :
attention to Article 820-40 of the NEC in USA {and to the Canadian a cia dad uthority to operate
Electrical Code in Canada) that provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall
be connected to the grounding system of the building, as close to
the point of cable entry as practical.