Panasonic Omnivision PV-V4640 Operating Instructions Manual page 2

Important Safeguards and Precautions
1
POLARIZED P
FOR YOUR SAFETY, READ AND
RETAIN ALL SAFETY AND OPERATING
INSTRUCTIONS. HEED ALL WARNINGS
IN THE MANUAL AND ON THE UNIT
INSTALLATION
POWER SOURCE CAUTION
Operate only from a power source indicated on the unit or in
this manual. If necessary, have your Electric Utility Service
Company or Video Products Dealer verify the power source
in your home.
POLARIZED OR GROUNDING PLUG
As a Safety feature, this Video product comes with either
a polarized power cord plug (one blada is wider than the
other), or a three-wire grounding type plug.
AUTION:
This plug will only fit into an outlet one way. If you cannot
fully insert the plug, try reversing it. If it still will not fit,
have an electrician install the proper wall outlet.
Do not defeat the safety feature by tampering with the plug.
GROUNDING PLUG CAUTION:
This plug will only fit into a three-hole grounding outlet.
If necessary, have an electrician install the proper outlet,
Do not defeat the safety feature by tampering with the plug.
3
POWER CORD
Make sure power cords are róutca so that they año noi ingly
to have anything rest on them, roll over them, or be in the
way of walking traffic. If an extension cord is used, make
sure it also has either a polarized or grounded plug and that
the cords can be securely connected, Frayed cords, damaged
plugs, and damaged or cracked wire insulation are hazardous
and should be reptaced by a qualified service technician.
Overloaded outlets and extension cords are fire hazards and
should be avoided.
DO NOT BLOCK VENTILATION HOLES
Ventilation openings in the cabinet release heat generated
during operation. lí they are blocked, heat build-up inside the
unit can cause failures that may result in a fire hazard or
heat damage to cassettes.
For protection, follow these rules:
a. Never cover ventilation slots or the unit
while in use, or operate the unit when placed
on a bed, sofa, rug, or other soft surface.
b. Avoid built-in installation, such as a book case
or rack, unless proper ventilation is provided.
AVOID EXTREMELY HOT LOCATIONS OR
SUDDEN TEMPERATURE CHANGES
Do not place the unit over or near any kind of heater
or regulator, in direct sunlight, inside a closed vehicle, etc..
Do not move the unit suddenly between areas of extreme
temperature variation. If the unit is suddenly moved from a
cold place to a warm place, moisture may condense tn the
unit and.on the tape.
TO AVOID PERSONAL INJURY
* Do not place unsecured equipment on a sloping surface.
* Do not'place this unit on any support
that is not firm, level, and adequately
strong. The unit could fall causing
serious injury to a child or adult and
damage to the unit.
* An appliance and cart combination
should be moved with care.
Quick stops, excessive force, and
uneven surfaces may cause the
appliance and cart combination to overturn.
» Caretully follow all operating instructions and use
the manufacturers recommended accessories when
operating this unit or connecting it to any other equipment.
Safety Precautions
R E F E R BERVICINO TO QUALIFIED SERVICE PERSONNEL
borne corresp
A A
Paca]
(CAUTION: TO REDUCE THE ASX OF ELECTRIC BHOCK,
DO NOT REMOVE COVER (0A BACK)
NO USER-BEAVICEABLE PARTS INSIDE
OUTDOOR ANTENNA INSTALLATION
SAFE ANTENNA AND CABLE CONNECTION
lf an outside antenna or cable system
is connected to the equipment, ie
be sure thé antenna or cable system
is grounded so as to provide some
protection against built up static
charges and voltage surges.
Section 810 of the National
Electrical Code, ANSI/NFPA 70
(in Canada, part 1 of the Canadian
Electrical Code) provides information
with respect to proper grounding of the
mast and supporting structure, grounding
ot the lead-in wire to an antenna discharge unit,
ANTEHMA
LEAD IN
WRE
OMSCHAROS VMIT
(HEC RECTION 10-20)
pa
service
ELECTRODE SYS:
WEC AAT 230, PART H)
GROUNDING CONDUCTORS:
" (HEC SECTION $1820)
QA CLA
t
size of grounding conductors, location of antenna discharge unit, connection |
to grounding electrodes and requirements for the grounding electrode. ;
KEEP ANTENNA CLEAR OF HIGH VOLTAGE POWER LINES
OR CIRCUITS
An outside antenna system should be located well away from power linas,
electric light or power circuits and where it will never come into contact with
these power sources if it should happen to falt. When installing an outside
antenna, extreme care should be taken to avoid touching power lines,
circuits or other power Sources as this could be fatal. Because of the
hazards involved, antenna installation should be left to a professional.
USING THE VIDEO UNIT
If the unit has been in storage or moved to a new location,
refer first to the INSTALLATION section of these safequards.
KEEP THIS VIDEO UNIT AWAY FROM WATER OR 1
2
1
MOISTURE OF ANY KIND.
IF EQUIPMENT iS EXPOSED TO RAIN, MOISTURE, OR
STRONG IMPACT, unplug the unit and have it inspected by a qualified
service technician before use.
DURING AN ELECTRICAL STORM
During a lightning storm, whether indoors or outdoors, or before leaving the
unit unused for extended penods of tima, disconnect all equipment from the
power source as well as the antenna and cable system.
WHEN THE UNIT IS PLUGGED IN
* Never expose the unit to rain or water. DO NOT OPERATE
if tiquid has been spilted into the unit. Immediately unplug the unit,
and have it inspected by a service technician. Fire and shock hazards
can result from electrical shorts caused by liquid contact inside.
* Never drop or push any object through openings in the unit. Some intemal parts
and contact can cause electric shock or fire hazard.
* Avoid placing the unit directly above or below your TV set as this may cause
carry hazardous voltages
electrical interference. Keep all magnets away from electronic equipment.
USING ACCESSORIES
Use only accessories recommended by the manufacturer to avoid risk of fire,
shock, or other hazards.
CLEANING THE UNIT
Unplug the unit. Then, use a clean, dry, chemically untreated cloth to gently
remove dust or debris. DO NOT USE cleaning fluids, aerosols, or forced air
that could over-spray, or seep into the unit and cause electrical shock,
Any substance such as wax, adhesive tape, etc. may mar the cabinet surface.
Exposure to greasy, humid, or dusty areas may adversely affect intemal parts.
SERVICE |
DO NOT SERVICE THIS PRODUCT YOURSELF
If, after carefully foltowing the detailed operating instructions, this Video
product does not operate properly, do not attempt to open or remove
covers, of make any adjustments not described in the manual.
Unplug the unit and contact a qualified service technician.
IF REPLACEMENT PARTS ARE REQUIRED
Make sure the service technician uses only parts specified
or those having the same safety charactenstics as the original
ified by the manufacturer,
rts. The use of
unauthorized substitutes may result in fire, electric shock, or other hazards.
3 HAVE THE SERVICE TECHNICIAN PERFORM A SAFETY CHECK
After any service or repairs to the unit, request the service technician to
conduct a through safe check as described in the manufacture's service
literature to insure that the video unit is in safe operating condition.
Warning: To prevent fire or shock hazard, do not expose this equipment to rain or moisture.
CAUTION: To prevent electric shock, match wide blade of plug to wide slot, fully insert.
Attention: Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la
ondante de la prise et pousser jusqu'au fond.
This symbol wams the user that uninsulated voltage within the unit may have sufficient magnitude to cause
electric shock. Therefore, it is dangerous to make any kind of contact with any inside part of this unit.
For assistance, call 1-800-211-PANA(7262).
This symbol alerts the user that important literature conceming the operation and maintenance of this unit
has been included. Therefore, it should be read carefully in order to avoid any problems.