Troubleshooting - Teac AG-V3050 Owner's Manual

TROUBLESHOOTING
Problem Probable Cause
Remedy
Power
No power Power cord is not plugged in.
Plug in the power cord securely.
Amplifier
Sound cannot be heard.
The required SPEAKERS select
button is not ON.
Set the required SPEAKERS select
button to ON.
The MUTING button is set to ON.
Be sure to set the MASTER
VOLUME control to minimum then
set the MUTING button to OFF.
The TAPE 2 MONITOR button is ON.
Set the TAPE 2 MONITOR button to
OFF.
Sound is only heard from one
channel.
The BALANCE control is set to one
end.
Adjust the BALANCE control.
One of the input cords is
disconnected.
Connect the input cords securely.
Low-frequencies are insufficient and
the image of mid-frequencies is not
fixed.
The plus and minus connections of
either front speaker are reversed.
Connect the speakers with the
correct polarities.
Hum or noise.
Turntable is not grounded.
Connect the ground wire to the
GND terminal on the rear panel.
The signal cords of the turntable
are not securely connected to the
PHONO terminals.
Connect the cords to the PHONO
terminals securely.
Audio equipment is too near the TV.
Tuner
Move the TV away from the audio
equipment.
No tuning.
The antenna is not connected.
Connect the antenna.
Auto tuning not possible.
Signal strength of stations is too
weak.
Perform manual tuning.
Use a better external antenna and
adjust its direction.
STEREO indicator fails to light
during stereo broadcasts.
FM MODE button is set to Mono
mode.
Set the FM MODE button to Stereo
mode.
Electromagnetic interference.
Ignition noise from cars.
Use the external antenna and install
it away from the street.
TV too near the receiver.
DF
Move the receiver away from the
TV.