Visioneer PaperPort OneTouch Installation Manual page 37

Click the drop-down arrow and
choose the transparency scanning
option from this menu,
The option "Scan Reflective Using"
is for scanning paper items, not
slides or negatives.
Tip: You can also start the Scan Manager Pro from the scanner buttons by setting a button to
"Configure Before Scanning." See "Selecting New Options for the Buttons" on page 9.
2. Click the drop-down menu at the top of the Scan Manager Pro and choose the type of transparency
to scan.
Scan 35mm Using:—choose this option to scan 35mm slide positives
Scan Negative Using:—choose this option to scan negative film or 35mm slide negatives
3. Click Preview to preview the image and, if necessary, adjust the various settings, then click Scan
when the image is what you want. See "Using Twain and Scan Manager Pro - for Performance Series
Scanners" on page 20 for details about scanning, and also see, "Adjusting the Settings on the Scan
Manager Pro" on page 22 for the steps to adjust the settings.
Tip: Set the resolution to 1200dpi or better when scanning your slides and negatives. See the section,
"Adjusting the Resolution and Sharpness" on page 24 for the steps to set the resolution.
4. When you are finished scanning, remove the masks from the scanner glass and store them in their
protective bag.
5. Choose Scan Reflective Using: from the Scan Manager Pro's drop-down menu to reset for scanning
paper items.
That setting turns off the transparency light in the document cover.
6. If you adjusted the resolution and other settings for scanning slides or film, reset those settings for
scanning paper items.
S 35 S
CANNING MM LIDES AND
N 33
EGATIVES