Visioneer PaperPort OneTouch Installation Manual page 31

U T
SING WAIN AND
To Auto Trim an item:
1. Click Auto Trim.
2. Click Trim.
The scanner senses the edges of the item on the glass and draws a dotted line around the image in
the window.
Check to make sure the dotted line encloses the image that you want.
A new Scan Info box on the lower left portion of the Scan Manager Pro shows the information for
the autotrimmed area.
3. If the dotted line is not exactly where you want it, put the pointer on the line and drag the mouse.
For example, if you want the scan to include a border around the image, you can drag the dotted
line to be slightly larger than the autotrimmed area.
To use the pointer to drag the line, make sure the pointer button is selected at the top of the
window.
4. When the trimmed area is what you want, click Scan.
To manually set the output size for an item:
1. To scan the entire item on the glass, click Same as Original. No sections are trimmed.
2. To set the output size yourself, click Same as Original to remove the checkmark.
The settings for the output size become active.
3. Put the pointer on the image and drag the mouse to enclose the section you want in the scanned
image.
As you drag the mouse, a dotted box appears on the image and the size settings change to reflect the
new output size area. You can also type in the size settings boxes.
■
Width and Height—the measurements of the final image after it's scanned; for example, if you
plan to print the image on a typical piece of paper, the width and height are 8.5 and 11.0 inches
■
Units—units of measurement for the new area; click the drop-down arrow and choose new units
if you want
■
Resolution—the dots-per-inch (dpi) setting for the new area
■
Scale—the amount of enlargement or reduction of the image to fill the width and height
measurements; for example, if you select a small area and have set the width and height to a paper
size, the scale automatically increases to enlarge the small image so it's the same size as the paper
A new Scan Info box on the lower left portion of the Scan Manager Pro shows the information for
the new area.
You can select multiple areas. A new Scan Info box appears for each one.
The following figure shows an example of a manually selected area.
Note: When you manually select an area, the settings on the other panels are for that selected area, not
the whole image. For example, the histogram on the resolution panel and the response curve on the
brightness and contrast panel refer to only your newly selected area.
S M P -
CAN ANAGER RO FOR
P S S
ERFORMANCE ERIES CANNERS
27