Electrolux IK2480BNR User Manual page 24

Table of Contents

Advertisement

Available languages

Available languages

Problem
Door is misaligned or interferes with
ventilation grill.
Door does not open easily.
The lamp does not work.
There is too much frost and ice.
Water flows on the rear plate of the
refrigerator.
There is too much condensed water
on the rear wall of the refrigerator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appliance is
too low/too high.
24
ENGLISH
Possible cause
The appliance is not levelled.
You attempted to re-open the door
immediately after closing.
The lamp is in stand-by mode.
The lamp is defective.
The door is not closed correctly.
The gasket is deformed or dirty.
Food products are not wrapped
properly.
Temperature is set incorrectly.
Appliance is fully loaded and is set
to the lowest temperature.
Temperature set in the appliance is
too low and the ambient tempera‐
ture is too high.
During the automatic defrosting
process, frost melts on the rear
plate.
Door was opened too frequently.
Door was not closed completely.
Stored food was not wrapped.
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
The Extra Freeze function or Extra
Cool function is switched on.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
Solution
Refer to installation instructions.
Wait a few seconds between closing
and re-opening of the door.
Close and open the door.
Contact the nearest Authorized
Service Centre.
Refer to "Closing the door" section.
Refer to "Closing the door" section.
Wrap the food products better.
Refer to "Control panel" chapter.
Set a higher temperature. Refer to
"Control panel" chapter.
Set a higher temperature. Refer to
"Control panel" chapter.
This is correct.
Open the door only when necessa‐
ry.
Make sure the door is closed com‐
pletely.
Wrap food in suitable packaging be‐
fore storing it in the appliance.
Attach the melting water outlet to
the evaporative tray.
Switch off Extra Freeze function or
Extra Cool function manually, or
wait until the function deactivates
automatically to set the temperature.
Refer to "Extra Freeze function" or
"Extra Cool function" section.
Refer to "Closing the door" section.
Let the food products temperature
decrease to room temperature be‐
fore storage.
Store less food products at the
same time.

Advertisement

Chapters

Table of Contents
loading

Table of Contents