Table of Contents
Advertisement
CONTROLS
▷
With hard accelerating or braking.
▷
When blinking.
▷
With hazard warning system switched on.
▷
In driving situation with high driving dynam-
ics.
▷
While Dynamic Stability Control is adjusting.
▷
Immediately following a steering interven-
tion by the vehicle systems.
▷
When actively merging back to your own
lane after passing.
Warning signal
Depending on the national-market version: in
the event of multiple active steering interven-
tions by the system within 3 minutes with-
out the driver's intervention at the steering
wheel during the steering intervention itself, an
acoustic warning will sound. A short warning
signal will sound at the second steering inter-
vention. Beginning with the third steering inter-
vention, a continuous warning will sound.
In addition, a Check Control message is dis-
played.
The warning signal and Check Control mes-
sage advise to pay closer attention to the lane.
End of warning
For instance, the warning or an active steering
intervention will be canceled in the following
situations:
▷
Automatically after a few seconds.
▷
When returning to your own lane.
▷
With hard accelerating or braking.
▷
With hazard warning system switched on.
▷
When blinking.
▷
While Dynamic Stability Control is adjusting
or is disabled.
▷
Immediately following a steering interven-
tion by the vehicle systems.
▷
With manual steering intervention.
182
Safety
Online Edition for Part no. 01405A5F6E0 - VI/22
▷
When another driver assistance system is
activated, if applicable.
▷
Lane boundaries are not detected.
▷
When the system limits are reached.
System limits
General information
Follow the system limits in the "Collision warn-
ing systems" chapter.
Functional limitations
The system may be limited in the following
situations:
▷
In the event of missing, worn, poorly visible,
merging, diverging, or multiple lane boun-
daries such as in construction areas.
▷
With lane boundaries that are covered in
snow, ice, dirt or water.
▷
In tight corners or on narrow roads.
▷
With lane boundaries that are covered by
objects.
▷
When driving very close to the vehicle in
front of you.
▷
Up to 10 seconds after drive readiness is
switched on via the Start/Stop button.
▷
While Dynamic Stability Control is disabled.
A Check Control message may be displayed
when the system is limited. Depending on the
national-market version, a yellow icon is also
illuminated.
Active Blind Spot Detection
Principle
Active Blind Spot Detection detects vehicles
in the blind spot or vehicles approaching from
behind in the adjacent lane.
The light in the exterior mirror emits warnings
at different steps.
Advertisement
Table of Contents
