Table of Contents
Advertisement
CONTROLS
Safety information
Warning
If adjustments have been made or the sen-
sitivity has been modified, oncoming traffic
may be momentarily blinded. There is a risk
of accident. If adjustments have been made
and the sensitivity has been modified, make
sure that oncoming traffic is not momentarily
blinded. Switch off the high beams manually
if required.
Functional requirements
▷
Setting at standstill only.
▷
Drive-ready state is switched on.
▷
Light is turned off.
Increasing sensitivity
Push the turn signal lever to the front for ap-
proximately 10 seconds.
A Check Control message is displayed. The
system responds more sensitively.
Resetting the sensitivity
Push the turn signal lever to the front again
for approx. 10 seconds or switch off the drive-
ready state.
The sensitivity of the Automatic High Beam
Assistant is reset to the factory settings.
System limits
The Automatic High Beam Assistant cannot
replace the driver's personal judgment of when
to use the high beams. In situations that re-
quire this, therefore dim manually.
The system is not fully functional in the follow-
ing situations, and driver intervention may be
necessary:
164
Lights
Online Edition for Part no. 01405A5F6E0 - VI/22
▷
In very unfavorable weather conditions,
such as fog or heavy precipitation.
▷
When detecting poorly-lit road users such
as pedestrians, cyclists, horseback riders
and wagons; when driving close to train or
ship traffic; or at animal crossings.
▷
In tight curves, on hilltops or in depressions,
in crossing traffic or half-obscured oncom-
ing traffic on highways.
▷
In poorly-lit towns and cities or in the pres-
ence of highly reflective signs.
▷
When the windshield in front of the interior
mirror is fogged up, dirty or covered with
stickers, etc.
Instrument lighting
Functional requirement
The brightness can only be adjusted when the
parking lights or low beams are turned on.
Setting the brightness
Adjust the brightness with the
thumbwheel.
Interior lighting
General information
Depending on the equipment version, interior
lights, footwell lights, entry lights, ambient
lighting, and speaker lighting are automatically
controlled.
Advertisement
Table of Contents
