Setting Up The Channel List - Initial Setup - Sony BRAVIA KDL-40S4100 Operating Instructions Manual

Getting Started
Setting Up the Channel List - Initial Setup
Ariel" you finish connecting your TV. you need to run Initial Setup, which
automatically sets up awfilable channels. The Initial Setup screen appears
when you turn on your TV for the first time. If you do not want to set up the
channels at this time, you can do it later by selecting the Auto Program
option in the Channel settings (see page 31 ).
1
2
3
POWER
Press 0
to turn on the TV.
The Initial
Setup
screen appears.
Press 11411, to highlight the desired
language and (_ to select.
The message "First please connect
cable or antenna. Allow 50+ minutes
for completion." and "Start auto
program now'?" appear, make sure you
already connected cable or antenna,
then select OK to start Auto
Program.
It" you want to start Auto Program
later, select Cancel.
4
5
6
The scanning of channels will start. If
you want to stop and run Auto
Program later, select Cancel.
When Auto Program is complete,
press @ to continue.
If the Initial Setup programming
found cable channels, you will be able
to scan antenna channels as well.
Connect the antenna using an A-B RF
switch (not supplied) and change the
switch to antenna then start Auto
Program to search antenna channels.
If the Initial Setup programming found antenna channels, the Auto
Program process will finish. If you want to scan cable channels, you
can do it later using the Channel settings.
To run Auto Program again at a later time
r7 Use the Auto Program feature as described on page 31.
To display the Picture in your Preferred Aspect Ratio
El Select the proper Wide Mode as described on pages 24 and 29.
22