Water Connection - Zanussi Z9282T Instructions For The Use And Care

Also make sure that the washing machine
does not touch walls, furniture, etc.
while working.
Water connection
The machine may either be plumbed in
or connected to existing taps.
Details are given below.
Water supply
Separate supplies of hot and cold water
are necessary. Single outlet gas or
electric heaters are not suitable.
If only cold water supply is available,
connect the two hoses to a cold water
tap.
Water outlet connection
The drain pipe from this machine must
connect into the main drain of the
premises, but not into the rainwater
drain.
Information as to the type of drain
servicing your premises can be obtained
from a builder or the Local Authority.
The curved end of the outlet hose should
be firmly hooked over the edge of a sink
or connected to a suitable drain pipe in
the wall or under the sink;
however, such a drain pipe should have a
built-in air break in order to avoid water
syphoning from the machine during
draining.
The top of the drain hose (curved end)
should not be lower than 50 cms (20 ins)
or higher than 85 cms (34 ins) from floor
level (fig. 4).
The water should be able to drain freely
and the end of the outlet hose must not
be under water.
It is, therefore, advisable that the drain
pipe, if used, has an internal diameter of
at least 4 ems (1,5 ins).
Also, ensure that the drain hose is not
chocked or placed in such a way as to
obstruct the normal water flow.
6
fig. 4