Advertisement
50 Series Top Jamb Arm Installation (Right Hand Shown)
1. Prepare door and frame.
1-1/2
(38)
1-3/4
(44)
2. Mount closer to frame.
or
x4
4. Connect arms and install
forearm screw.
2nd
The 50 Series Non Hold Open Closer - Top Jamb Mount has now been installed.
��
Go to page 2 for closer adjustments and decorative cap or cover installation.
4
9-1/16
(230)
3/4
(19)
1/2
(13)
6
(152)
3. Choose arm placement in shoe and install separate arms.
5. Preload spring and tighten forearm screw.
1st
Copyright © 2016, 2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part without the
express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Approved 2023-02-24
50 Series Non-Hold Open Closer
Opening
A
to 100°
101° to 120°
Top of
Door
*121° to 180°
*Door/Wall/Hardware/Jamb conditions permitting
C L
– 7-1/2%
Weaker
or
or
+ 7-1/2%
Stronger
Rotating arm preloads
closer spring power.
Dimension "A"
7-1/2 (191)
6 (152)
3-1/2 (89)
A longer connecting rod
is required for reveals
greater than 3" (76mm)
or
x2
RH and LH:
Position flat at S
1st
Rotate elbow until
2nd
perpendicular to frame.
80-9350-2531-010 Rev 2 02/23
Reveal
Connecting Rod is
Advertisement
