Hama EWS-152 Operating Instructions Manual page 9

e
6.2. Basic and manual settings
Automatic setting using the DCF signal
+ After the base station is switched on for the first time and successful transmission
is established between the base station and the measuring station, the clock will
automaticaly search for a DCF signal. During the search, the wireless symbol (6)
will flash.
Active
Successful — signal is being received
Deactivated ©
+ If the station still does not receive a signal, press and hold the w button (9) for
approx. 3 seconds to start the manual search for the DCF signal. The wireless
symbol (6) will start to flash
* The search process takes about 7 minutes, If the search fails, it ends and is
repeated at the next clock hour. The wireless symbol (6) will go out.
+ Inthe meantime you can, however, set the time and the date manually.
* The clock automatically continues to search for the DCF signal on a daily basis
(between 1:00 a.m. and 3:00 a.m.). If the signal is received successfully, the
manually-set time and date are overwritten.
©
23126man de en el es frit pl ru skindd 7 30.10.14 10:2