Table of Contents
Advertisement
XC-ST series
@
weg all
XC-ST70/ST50/ST30
XC-ST70CE/ST50CE/ST30CE
System Components
The CCD Black-and-White Video Camera Module XC-ST series system
comprises the following optional products (available separately).
@ CCD Black-and-White Video Camera Module
This is a small-size, high-resolution, monochrome video camera module
using an interline transfer CCD image sensor.
© CCXC-12P02N (2m, 6.6ftVO5N (5m, 16.4ft)/10N (10m, 32.8ft)/25N
(25m, 82ft) camera cable
This is attached to the DC IN/SYNC connector of the camera module and is
used for power supply, transmission of video signals, and exchange of sync
signals.
© C-mount lens
Recommended lens: VCL-O8YM/12YM/16Y-M/25Y-M/SOY-M
© DC-700/700CE camera adaptor
This is connected to the camera module to enable power supply from
ordinary AC power source, and also handies transmission of video signals
from the camera module and exchange of sync signals between the camera
module and an external sync signal generator.
© VCT-ST70I tripod adaptor
This attaches to the bottom of the camera module to fix the camera module
to a tripod.
Connection example
Connecting DC-700/700CE (not supplied)
Connect the camera module to the power via the camera adaptor DC-700/
700CE.
For details on the camera adaptor DC-700/700CE, see the DC-700/700CE
Instruction Manual.
@ Monitor
@ DC IN/SYNC connector
© C-mount lens (e.g. VCL-16Y-M)
@ To VIDEO 1 connector
© 75-ohm coaxial cable etc.
@® To CAMERA connector
© Camera cable (e.g. CCXC-12P05N)
@ To AC IN connector
© TRIG generator, Image processor
© To AC power source
@ Sync. signal generator
© To HD connector
@® To VD/SYNC connector
® HD output
® VD output
Location and Function of Parts and Operation
@ Lens mount (C-mount)
Attach any C-mount lens or other optical equipment.
The lens must not project more than 7 mm (9/32 inch) from the lens mount.
@® Lens mount face
@® 7 mm (9/32 inch) or less
© Reference hole (Top)
© Reference hole/Tripod screw holes (bottom)
These precision screw holes are for locking the camera module.
Locking
the camera module into these holes secures the optical! axis alignment.
For details on dimensions, etc., see "About the User's Guide" on the lower right of the
back side.
You can install the camera on a tripod. To install on a tripod, you will need
to install a tripod adaptor VCT-ST70I to the camera on the reference holes
of the bottom of the camera.
1-3 (E)
Advertisement
Table of Contents
