Table of Contents
Advertisement
Setting the Supervisor Password
(enabling, changing, disabling)
1
Run the Setup Utility
(o page 46)
2
Using @ and |§, select [Supervisor Setup], then press
3 Using
and
select [Supervisor Password], then press
:|
4 9To
enable or change your supervisor password
Enter your password at the [Enter Supervisor Password], then press (I^
• Your password will not be displayed on the screen
• Please limit your password to seven characters. Note that there is no dis-
tinction between upper and lower case letteis
• White colored keys can be used. Note that the space bar and function keys
cannot be used
• Do not input your password while holding down on
or ^
• Use only the upper horizontal row of numeric keys to input your user pass¬
word The numeric keys combined with alphabet keys on the lower key¬
board cannot be used
• Do not forget your password If a password is forgotten you will be unable
to use your computer
#To disable your supervisor password
Using @ and |^, select [Delete Supervisor Password], then press
Go to step
7
5
Reenter your password at the [Enter Supervisor Password
Again]
(This is for confirmation purposes )
Xnote)-,
When you do not want the User Password enabled, changed, or disabled
without permission,
use ^ and ^ to select [User Password Protection], then set [Enable] with
6
Using
and
select [Set Supervisor Password], then press
fedi
7 At the confirmation screen, press
8
Press
to end the password setting procedure
9
Close the Setup Utility
page 46)
25
Advertisement
Table of Contents
