Advertisement
Fig. 7-8
TO
DECK "AMP
UX-A4 B/E/G/GI/EN
™ Disassembly of CD Player Ass'y and Front Panel Ass'y
© Metal Cover (Fig. 7-8)
1. Remove the four screws
B) retaining the metal cover
from the body.
2. Remove the one screw 6) retaining the metal cover from
the back surface of the body.
3. Dismount the metal cover while expanding it outward.
® Front Panel Ass'y (Fig. 7-8)
From the connector CN701
on the LCD microcomputer
PC.
board,
remove
the card wire outgoing
from the
connector CN708 on the operation key switch PC. board
attached to the front panel ass'y, and separate the card
wire from the front panel ass'y.
© CD Player Ass'y (Fig. 7-8 ~ 11)
1. After turning the body upside down, insert a minus screw
driver
into the
hole
@) engaging
the system
wire
inserting wire holder and the rear cover, and disengage
the holder and cover. Then, dismount the wire holder
while pulling it out.
2. Remove the two screws
retaining the rear panel from
the body.
3. After inserting a minus screw driver between the four
engagement points ©) fixing the rears cover, release the
engagements and separate the rear cover from the body.
4. After inserting a minus screw driver between the front
panel and chassis, release the four engagement points
() fixing the front panel ass'y, and separate the front
panel ass'y from the body.
.
5. Remove the two screws @) retaining both sides of the
CD player ass'y from the chassis.
6. After expanding the right and left sides of the chassis
outward, release the right and left engagements () of
the CD player ass'y and chassis, and separate the CD
player ass'y from the body.
H@ Analytic Drawing (3) Parts List [M](3]
SDSF30082
SCREW
VJC2411-004
METAL
COVER
SDST3006M
SCREW
VND4221-001
CLASS
1 LABEL
VJF4003-003
FOOT
SBSF3008N
T.SCREW
VYH7707-001
WIRE
HOLDER
VJG1137-001
REAR
PANEL(T)
VYN9214-001
NAME
PLATE
SBSF3008N
T.SCREW
SBSF3008N
T.SCREW
EMV7130-017
WIRE
HOLDER
VMPO0092-001
SYSTEM
WIRE
ASY
7. From the connector CN704 on the LCD microcomputer
PC. board, dismount the door switch PC. board attached
to the CD player ass'y and the #6PIN connector outgo-
ing from the door motor PC. board.
8. From the connector CN706 on the LCD microcomputer
PC. board, discmount the card wire outgoing from the
connector CN601 on the CD amplifier P.-C. board attached
to the CD player ass'y.
9. From the connector CN705 on the LCD microcomputer
PC. board, dismount the #PIN parallel wire outgoing from
FW501
on the CD amplifier P.C. board.
Front panel
System wire holder
Fig. 7-9
Fig. 7-10
Rear cover
System wire holder
Fig. 7-71
REMARKS
CD+CHASSIS
UNIT
METAL
COVER
SYSTEM
WIRE
94H
FOR
SYSTEM
WIRE
JWFO1
(Ne, # 890) 29
Advertisement
