Viking DBCV3638 Installation Manual page 2

NOTE: IF INSTALLING HOOD WITH WARMING
SHELF PANEL, INSTALL WARMING SHELF PANEL
FIRST.
IMPORTANT - PLEASE READ AND SAVE THESE
INSTRUCTIONS
•Before beginning, please read these instructions completely and
carefully.
•Do not remove permanently affixed labels, warnings, or plates
from the product. This may void the warranty.
•Please observe all local and national codes and ordinances. If no
local codes are applicable, wire in accordance with the National
Electrical Code, ANSI/NFPA 70-1990.
•Outdoor approved models should be installed in a covered non-
enclosed area and should be protected from the elements as
much as possible.
•The installer should leave these instructions with the consumer
who should retain for local inspector's use and for future
reference.
•Check with a qualified and trained installer or local codes for
makeup air requirement, if any.
This hood is for residential installation only and is not designed for
installation over a commercial product. Make sure power is off at
the main circuit breaker or fuse box before making connections.
To avoid risk of fire, electric shock, or injury to persons, turn off the
electricity to the hood from the power supply before servicing or
cleaning.
Viking Range hoods are equipped with variable speed controls for
blowers. These units will not function with a single speed
ventilator. All Viking Range ventilator kits are designed specifically
for use with Viking Range hoods. Use of any non-Viking Range
ventilator kit will void the hood warranty.
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
1. Use this unit only in the manner intended by the
manufacturer. If you have any questions, contact the
manufacturer.
2. Before servicing or cleaning unit, switch power off at service
panel and lock service panel to prevent power from being
switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
IMPORTANT SERVICE INSTRUCTOINS
-CAUTION-
For general ventilating use only. Do not use to
exhaust hazardous or explosive materials and
vapors.
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK,
OR INJURY TO PERSONS, RANGEHOODS MUST BE
INSTALLED WITH THE VENTILATORS THAT ARE
SPECIFIED ON THEIR CARTON INDICATING
SUITABILITY WITH THIS MODEL. OTHER VENTILATORS
CANNOT BE SUBSTITUTED.
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK,
OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction.
2. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow
the heating equipment manufacturer' s guideline and
safety standards such as those published by the
National Fire Protection Association (NFPA), and the
American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code
authorities.
3. When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
4. Ducted fans must always be vented to the outdoors.
5. WARNING!: To reduce the risk of fire, use only metal
ductwork.
6. CAUTION!: To reduce risk of fire and to properly
exhaust air, be sure to duct air outside. Do not vent
exhaust air into spaces within walls or ceilings, or into
attics, crawl spaces, or garages.
WARNING - TO REDUCE THE RISK OF INJURY TO
PERSONS IN THE EVENT OF A RANGETOP GREASE
FIRE, OBSERVE THE FOLLOWING:
(based on "Kitchen Firesafety Tips" published by
1. SMOTHER FLAMES with a close-fitted lid, cookie
sheet, or metal tray, then turn off the burner. BE
CAREFUL TO PREVENT BURNS. If the flames do not
go out immediately, EVACUATE AND CALL THE FIRE
DEPARTMENT.
2. NEVER PICK UP A FLAMING PAN. You may be
burned.
3. DO NOT USE WATER, including wet dishcloths or
towels - a violent steam explosion will result.
4. Use an extinguisher ONLY if:
•You know you have a Class ABC extinguisher, and you
already know how to operate it.
•The fire is small and contained in the area where it
started.
•The fire department is being called.
•You can fight the fire with your back to an exit.
2
CAUTION
WARNING
NFPA)