Download Print this page

Aiwa NSX-D77 Operating Instructions Manual page 22

Compact disc stereo system
Hide thumbs Also See for NSX-D77:

Advertisement

The clock is displayed. (The ":" between the hours and minutes
flashes.) When the power cord is plugged into an AC outlet for
the first time after purchase or when the clock setting is canceled
due to a power failure, the entire clock display flashes.
1 Press CLOCK.
2 Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute.
<4 or PP is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
3 Press ENTER or Bl.
The clock starts from 00 second.
To restore an original clock setting
Press CLOCK before completing step 3 to restore the previous
time setting. This cancels any new setting.
To view the clock when another display is in the display
Press CLOCK.
The time is displayed for 4 seconds and then
the original display reappears. However, the clock cannot. be
displayed during recording.
To switch to the 24-hour standard
_
Press CLOCK and then press I within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
In the 12-hour standard, "AM 12:00" indicates midnight and "PM
12:00" indicates noon.
If the clock display flashes
This caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
If the power-economizing mode (page 6) is on, the unit blacks
out when the power is turned off. To view the clock, press CLOCK
so that the time is displayed for 4 seconds.
21 ENGLISH
The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press SLEEP.
2 Within 4 seconds, press <<
or >> to specify
the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
MULTI JOG is also available instead of << and >.
Specified time
ee
ee
el
To check the time remaining until the power is turned off
Press SLEEP once.
The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press SLEEP twice so that "SLEEP oFF" appears on the display.

Advertisement

loading