Aiwa NSX-D77 Operating Instructions Manual page 16

@/OREC/
REC MUTE
>/<>
Preparation
* Set the tape to the point where recording will start.
+ Use Type I (normal) and Type II (high/CrOz) tapes for recording.
2 Press REV MODE (DECK 2) to select the reverse
mode.
To record on one side only, select =.
To record on both sides, select =) or (=).
3 Press DOLBY NR to turn Dolby NR on or off.
To record with DOLBY NR, turn on OO NR.
To record without DOLBY NR, turn off OO NR.
4 Press function (CD, TUNER/BAND, VIDEO/AUX or
MD) and prepare the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNER/BAND and
tune in to a station.
To record from a connected source, press VIDEO/AUX or
MD.
5 Press @ REC/REC MUTE to start recording.
When recording from a connected source, start playback of
the source.
REC
When the selected function is CD, playback and recording
start simultaneously.
15 ENGLISH
To stop recording, press I.
To start recording with the remote control
First press @/O REC/REC MUTE, and then press >/<4> within
2 seconds.
Recording with BBE
Sawer ee Pa eenSanae se
INSERTING BLANK SPACES
VIDEO/AUX or MD.)
2 Press Ill to resume recording.
To erase a recording
Make sure the microphone(s) is(are) not connected to this unit
and set the microphone volume and the echo level to OFF (page
19).
1 Insert the tape to be erased into deck 2 and press TAPE/
DECK 1/2 to display "TP 2".
3 Set the reverse mode by pressing REV MODE (DECK 2).
4 Press @ REC/REC MUTE to start the erasure.