Advertisement
Device Installation/ 设备安装
B. Pole-Mount/ 立杆抱装
4
Align the top cover of the PTZ dome camera with the bracket, screw it into the bracket. Once it is screwed in,
use the M2.5 hex key to tighten the screw on the bracket and installation of the top cover is complete.
将球机上盖对准支架，然后旋转球机上盖，将上盖安装到支架上，最后用内六角扳手（M2.5 规格）拧紧支架上的紧定螺钉，
完成球机上盖的安装。
B. Pole-Mount/ 立杆抱装
The PTZ dome camera is delivered with a handle attached, to make it easier to pick up and carry the camera.
5
Please use the handle, not the pigtails, to carry the camera.
由于球机比较重，球机提手在出货的时候已经安装在球机上，便于施工时搬运球机；设备搬运的时候要求通过提手搬运，
不允许通过提尾线搬运设备。
Correct:
Carry the
camera
using the
handle
正确方式：
通过提手搬
运设备
3
2
1
Wrong:
Carry the
camera
using the
pigtails
错误方式：
通过尾线搬
运设备
B. Pole-Mount/ 立杆抱装
Use the mounting ear on one side of the PTZ dome camera to attach the device to the top cover. Use the safety
6
rope to connect the camera, and connect the external cables to the pigtail. After the pigtail has been connected,
close up the top and use the M6 hex key to tighten the three screws on the top cover of the camera.
首先将球机安全绳一端的卡扣挂到支架挂耳上，球机侧面的挂耳挂装到上盖的挂钩上；然后将线缆与球机的尾线连接；最
后用内六角扳手（M6 规格）拧紧球机上盖的三颗螺钉。
NOTE/ 说明
• For cable connection, waterproofing, and insulation procedures, see page6"Cable Connection and
Waterproofing and Insulation".
连接线缆和防水、绝缘处理，参见P6" 连接线缆和防水绝缘处理"。
• After the installation is complete, remove • the handle from the safety rope and ensure that the hex nuts
on the buckles are tightened. The actual handle and buckles may differ from the examples in this guide.
安装完毕后，取下安全绳上的提手；确认已经拧紧卡扣六角螺母。提手和卡扣以实际发货为准。
• After the installation, verify that the protective film on the lens has been removed. Remove the fixing
rubber strip from the camera body.
安装完成后，请检查镜头保护膜，确认已撕掉镜头上的保护膜，撕掉机身的固定胶条。
4
4
2
1
Safety rope
安全绳
3
Advertisement
