Sony UDA-1 Service Manual page 63

DIGITAL BOARD IC508 TUSB1210BRHBR (USB TRANSCEIVER)
Pin No. Pin Name
1 REFCLK
2 NXT
3 to 7 DATA0 to DATA4
8 NC_8
9, 10 DATA5, DATA6
11 CS
12 VDD15
13 DATA7
14 CFG
15, 16 NC_15, NC_16
17 CPEN
18 DP
19 DM
20 VDD33
21 VBAT
22 VBUS
23 ID
24, 25 NC_24, NC_25
26 CLOCK
27 RESTEB
28 VDD18_28
29 STP
30 VDD18_30
31 DIR
32 VDDIO
I/O
Reference clock input terminal
I Input or output setting terminal for CLOCK (pin 26)
Fixed at "L" in this unit
O NXT signal output to the USB controller
I/O Two-way ULPI data bus with the USB controller
- Not used
I/O Two-way ULPI data bus with the USB controller
Chip select signal input terminal
I
Fixed at "H" in this unit
- Power supply terminal (+1.5V)
I/O Two-way ULPI data bus with the USB controller
Reference clock frequency confi guration terminal for REFCLK (pin 1)
I
"L": 19.2 MHz, "H": 26 MHz
- Not used
O VBUS power on/off control signal output to the USB switch
I/O Two-way USB serial data (+) bus with the USB switch
I/O Two-way USB serial data (–) bus with the USB switch
- Power supply terminal (+3.3V)
- Power supply terminal (+3.3V)
- Power supply terminal (+5V)
I/O Identifi cation signal input/output terminal
- Not used
I Clock signal input from the USB controller
I Reset signal input from the USB controller
- Power supply terminal (+1.8V)
I STP signal input from the USB controller
- Power supply terminal (+1.8V)
O DIR signal output to the USB controller
- Power supply terminal (+1.8V)
Description
"L": input mode, "H": output mode
"L": power down, "H": normal operation
"H": VBUS power on
Not used
"L": reset
UDA-1
63