Advertisement
AV-35750
AV-35770
REMOVING THE CRT.
CRT CHANGE TABLE
*
Replacement of the CRT should be performed by two or more
persons.
1. Putting the CRT change table on soft cloth, the CRT change
table should also be covered with such soft cloth.
(shown in Fig. 3)
2. While keeping the surface of CRT down, mount the TV set on
the CRT change table balanced will as shown in Fig. 4.
3. Remove four screws marked by arrows with a box type screw
driver as shown in Fig. 4.
@
Since the cabinet will drop when screws have been removed,
be sure to support the cabinet with hands.
4. After four screws have been removed, put the cabinet siowly
on cloth (At this time, be carefully so as not to damage the
front surface of the cabinet) shown in Fig.5.
@
The
CRT
should
be assembled
according
to the opposite
sequence of its dismounting steps.
*
The CRT change table should preferably be smaller than the
CRT surface, and its height be about 35cm.
vT
a
'
rr carta
tan
BOX
TYPE
SCREW
DRIVER
COATING OF SILICON GREASE
FOR
ELECTRICAL INSULATION ON THE CRT
ANODE CAP SECTION
*
Silicon grease product No.: KS - 650N
Anode button
Approx.
Silicon grease
20mm(Do not
|
should be coated
coat greaseon
->
<-
by 5mm or more
this section).
from the outside
:
diameter of
|
anode cap.
;
Anode button
(No sticking of
silicon grease)
Silicon grease coating
Coating position
of silicon grease
Anode cap
{
3
Fig. 6
Fig. 7
(No.5 1130) 9
Advertisement
