Advertisement
58EN
When
the System Select Switch is set to "VIDEO":
Recording
cannot
be performed.
• Make sure tile Erase Protection
tab is in tile position
that allows
recording.
If not, slide the tab. Some cassettes have removable
tabs. If the tab has been removed,
cover the hole with adhesive
tape (_L__
_ pg. 12).
• If the System Select Switch is set to "D.S.C.",
it is not possible
to record onto the tape. Change the Switch
position to
"VIDEO"
(_L _" pg. 18).
Recording
does not staff.
• The camcorder
Power Switch has not been set to
"CAMERA"
("AUTO"
(r "PRO ")fiZZ" pg. 18).
Animation or Time-Lapseis not
available.
The tape is running,
but there is no
playback picture.
• Before recording
in the Animation
mode at the very beginning
of a tape, set the carncorder
to the Recording
mode for about 5
seconds, so that the tape runs smoothly.
Using the Fade-in
function
at this point is a good way to begin an animated
program (L _" pg. 35, 56).
• The TV has not been set to its VIDEO
mode or channel.
• If A!V connection
is used, the TV's VIDEOfTV
Switch
has not
been set to VIDE(-).
Playback cannot be performed.
• If the System Select Switch is set to "D.S.C.",
it is not possible
to play back a tal:le. Change the Switch
i:losition to "VIDE(-)"
Cd_" pg. 39).
Playback picture isblurred or
interrupted.
• The vide() heads are dirty or worn out. Consult your nearest
JVC dealer for head cleaning
or replacement.
The counter
indication
is blurred
during
Still playback.
The.ta_e
stops during
fast-forward
or
rewind.
• This is normal.
® The Counter Memory
Function
has been activated
(_z_*" pg. 40).
Rewinding
or fast-forwarding
cannot be
performed.
The pidure
is b[urred
in the Quick
Review or Retake mode.
• The tape is already fully wound
on one reel or the other.
• This is normal while
recording
in the EP mode. Some noise
may be present while
recording
in the SP mode (:d_"pg. 14).
The date and time displays
disappear.
• If you remove the power source from the carncorder
while the
power is on, all settings and selections
are erased. Make sure to
turn the camcorder's
power off before disconnecting
the power
source.
The wrong date and time are displayed/
recorded.
• If you have not performed
Date/Time
Setting (LIS" pg. l 3), the
date and time are not displayed/recorded
correctly.
Be sure that
Date/Time
setting is carried out.
The tape will not eject.
• The battery pack is running low.
• If the LCD monitor
is not open over 60 degrees, EJECT switch
does not fLmction.
Advertisement
