Table of Contents
Advertisement
Using the USB connector
Your stock board has a USB connector under the display. Instructions
and software downloads are available at macdevpaintball.com.
Please note: USB is only used for firmware updates, not for everyday
settings changes.
Changing the front grip angle
Your Prime XTS front grip can be used ina an 8 degree or vertical
position. It is shipped in the 8 degree position. To change it to vertical,
remove the frame completely, and follow these steps:
Remove the cap using
your allen key
Slide the grip
rubber off the
core.
Rotate the block by 180 degrees
and re-install the core in the new
position
USB
location
Remove the core,
and the screws
holding the block.
Advertisement
Table of Contents
Need help?
Do you have a question about the PRIME XTS and is the answer not in the manual?
Questions and answers