Advertisement
3.
Insert extension arm into center hinge
and thread height adjustment handle through
center hinge into extension arm to secure
(see Figure 5).
Extension
Arm
Figure 5. Attaching extension arm and height
adjustment handle.
4.
Extend legs fully to ensure roller stand is
stable.
5.
Attach pivoting head to top of extension arm
with (2) M6-1 x 35 button head cap screw,
(2) 6mm flat washers, and (2) M6-1 lock nuts
(see Figure 6).
Figure 6. Installing pivoting head.
Model T33692 (Mfd. 05/23)
6.
Height
Adjustment
Handle
Adjusting Head
Lift up on head to disengage pivot stop, then
rotate head into positive stop at desired position.
Positive stop does not allow further movement
(see Figure 8).
x 2
Check roller stand. It should look similar to
the one shown in Figure 7.
Figure 7. T33692 assembled.
Flat
Roller
Surface
Ball
Figure 8. Three head positions.
11
⁄
"
1
2
Ball
Bearing
Roller
-3-
Advertisement
