Advertisement
• DO NOT exceed roller stand weight
capacity of 150 lbs. Sudden change in
dynamic load at maximum weight capac-
ity could cause roller stand to tip or
collapse, resulting in serious personal
injury or property damage.
• Make sure roller stand legs are fully
extended and roller stand is on flat sur-
face before using.
• Stand height should be set level with bot-
tom of workpiece.
• Fully tighten height adjustment handle
lever before placing a workpiece on roller
stand.
• Do not loosen or try to adjust height
adjustment lever while stand is support-
ing workpiece.
• Periodically check all fasteners and tight-
en, if necessary, prior to use.
Failure to follow warnings can result in seri-
ous personal injury or property damage.
Wear safety glasses during
the entire setup process!
Assembly
Items Needed
Safety Glasses (for each person) .................1 Pr.
Shop Rags ......................................... As Needed
-2-
To assemble 3-in-1 roller stand:
1.
Attach feet to legs using (4) M6-1 x 45 button
head cap screws (see Figure 3).
Figure 3. Attaching feet to legs.
2.
Insert legs into center hinge and secure with
(2) M8-1.25 x 45 button head cap screws, (2)
8mm flat washers, and (2) M8-1.25 lock nuts
(see Figure 4).
Qty
Figure 4. Attaching legs to center hinge.
x 4
x 2
Model T33692 (Mfd. 05/23)
Advertisement
