Advertisement
• This stand was specifically designed for
the G0969 Scroll Saw. DO NOT mount
any machine but the G0969 Scroll Saw on
this stand. Doing so could cause stand to
tip or collapse, resulting in serious per-
sonal injury or property damage.
• Periodically check all fasteners and tight-
en, if necessary, prior to use.
Wear safety glasses during
the entire setup process!
Assembly
Items Needed
Wrench or Socket 12mm ................................... 1
Open-End Wrenches
⁄
9
16
Additional Person .............................................. 1
To assemble scroll saw stand:
Remove (4) leveling feet and (8)
1.
nuts from G0969 Scroll Saw base and install
on (4) adjustable leg extensions, as shown in
Figure 3.
Attach (4) adjustable leg extensions to bot-
2.
tom of legs with (8)
bolts,
⁄
" flat washers, and
5
16
(see Figure 3).
Figure 3. Adjustable leg extensions attached to
legs.
-2-
Qty
" .................................. 2
⁄
"-16 hex
3
8
⁄
"-18 x
⁄
" carriage
5
1
16
2
⁄
"-18 hex nuts
5
16
x 8
Adjustable
Leg Extension
(1 of 4)
x 4
Attach (1) long bottom brace to (2) legs
3.
with (2)
⁄
"-18 x
5
1
16
washers, and
⁄
"-18 hex nuts, as shown in
5
16
Figure 4.
Note: Only hand tighten all fasteners for now.
You will be told when to tighten fasteners
later in these instructions.
Legs
Long Bottom
Brace
Figure 4. Long bottom brace attached to legs.
Repeat Step 3 with remaining (1) long bottom
4.
brace and (2) legs.
Attach (2) leg assemblies with (2) short bot-
5.
tom braces, (4)
⁄
5
16
⁄
" flat washers, and
5
16
shown in Figure 5.
x 4
Short Bottom
Brace (1 of 2)
Figure 5. Leg assemblies attached with short
bottom braces.
T33905 Scroll Saw Stand (Mfd. 07/23+)
⁄
" carriage bolts,
⁄
" flat
5
2
16
x 2
"-18 x
⁄
" carriage bolts,
1
2
⁄
"-18 hex nuts, as
5
16
Advertisement
