HOMCOM 820-037 Manual page 3

● CAUTION: Some parts of this product can become very hot and cause burns. Particular
attention has to be given where children and vulnerable people are present.
● WARNING: This heater is not equipped with a device to control the room temperature. Do
not use this heater in small rooms when they are occupied by persons not capable of
leaving the room on their own, unless constant supervision is provided.
● Regarding the instructions for replacing bulb, thanks to refer to the below paragraph of
the manual.
● TO RESET TERMPERATURING LIMITING CONTROL DISCONNECT POWER USING
PLUG CAP OR MAIN SWITCH FOR 5 MIN.
● Hyperthermia can result in death. Symptoms of hyperthermia include high body
temperature, headache, nausea, vomiting, tiredness, dizziness, fainting, and rapid pulse.
If you begin to experience symptoms related to hyperthermia, turn off the heater and
seek medical attention.
● To avoid excessive room temperatures which can cause hyperthermia: DO NOT leave
product running unattended in a confined space around infants, or individuals with
reduced physical, sensory, or mental capabilities.
Operating Instructions
Never cover the heater or obstruct the opening at the base of the heater, this could
cause overheating and consequent risk of fire.
Never move the heater when it is operating, this could cause the bulb breakdown.
Please turn the heater off if you want to move it.
When you turn the heater on for the first time you may notice a slight odor, this is harmless
and will stop after a short amount of time.
Heater Control Panel
Insert Plug into Socket
The following switches are located under the controls cover at the front of the heater.
● Switch (3a) Switches ON/OFF electricity supply to the heater and flame effect.
Note: This switch must be in the ON position for heating operation.
● Switch (3b) Switches ON/OFF 750W heat output.
● Switch (3c) Switches ON/OFF 1500W output with switch 3b.
Note: The flame effect can be operated with or without heat.
Rotate thermostat control (1) clockwise or anti-clockwise to achieve desired room
temperature.
Increase or decrease the flame effect by rotating the flame adjustment switch (2).
SAVE THESE INSTRUCTIONS.
I
1 3a
I II
3b 3c
3
2