Nice IT4WIFI Instructions And Warnings For Installation And Use page 6

4.2 - Initial set-up with MyNice (iOS) technology
To run the procedure, the person must be near the IT4WIFI device, led L3 must be lit steady green and led L2 flashing green. Should this not be the case,
run the Reset procedure (Chapter 5). Moreover, ensure that the smartphone is connected to a Wi-Fi network that supports the Bonjour service.
Table 3 - iPhone with iOS 13.0 operat-
ing system and later versions
01. Open
the
"MyNice" app and
select Configure
button if no auto-
mation are con-
figured or press
the + button oth-
erwise.
02. Select add an
"Automation" and
then "Add via Wi-
Fi".
On next view
select "Add IT-
4WIFI".
03. Select "Next",
unless your ac-
cessory is already
listed from net-
work available
device, because
Wi-Fi was already
configured and
tap Continue.
5 – English
04. Only if the acces-
sory is new.
Go on the Wi-Fi
settings of the
phone and select
the IT4WIFI. Af-
ter that select the
network you want
it to join and press
"Next".
05. Go back to the app and press
"Continue".
06. Enter accessory
MAC address (last
6 digits as high-
lighted), printed on
product label.
Enter setup code
(8 numbers inside
rectangle), printed
on product label,
and tap Continue.
After that tap Con-
figure.
MyNice - Android
07. Enter automation name and select
its environment or room.
If environment is not yet defined,
you can change it later.
Save automation with "Save" but-
ton.
08. Now you can con-
trol your automa-
tion from dash-
board with a short
tap or entering
in commands list
with long tap.
From settings you
can change ac-
cessory settings
and remove auto-
mation.
If the procedure described does not terminate
successfully, check that the requirements indicated
at the beginning of the manual are satisfied, run the
IT4WIFI reset procedure using the P button (Chapter
5) then try again.
MyNice - iOS