Viking Designer DDFB304 Installation Manual page 5

I I N N S S T T A A L L L L A A T T I I O O N N
F F r r e e n n c c h h - - D D o o o o r r B B o o t t t t o o m m M M o o u u n n t t D D o o o o r r R R e e m m o o v v a a l l
1. Unplug power cord from power source.
2. Remove toe grille.
3. Remove top hinge covers from refrigerator
doors by removing Phillips screw and retain
screw and cover for later use.
4. Unscrew 5/16" hex head screws from top hinge
to remove hinge and retain all screws for later
use.
5. Lift right side refrigerator door from center hinge
pin. Remove door closure from center hinge pin
on the right side and retain for later use.
6. Disconnect wire harness on top of left side
refrigerator door top hinge. Release two-pin
connector by pressing junction point with a flat
blade screwdriver or fingernail. Green ground
wire remains attached to the hinge.
P P u u l l l l o o u u t t F F r r e e e e z z e e r r D D r r a a w w e e r r R R e e m m o o v v a a l l
DANGER
To prevent accidental child entrapment or suffocation risk,
do not remove the divider in the top freezer basket.
1. Pull drawer open to full extension.
2. Tilt the lower basket forward and lift to remove.
3. Lift top of drawer front to unhook the drawer
from the slides. Lift door front out to remove
7. Unscrew 5/16" hex head screws from top
hinge to remove hinge and retain all screws
for later use. Lift left side refrigerator door,
along with top hinge, from center hinge pin.
8. Remove phillips screws to remove right and
left hinges and retain
all screws for later
use.
Right
side
door
closure
CAUTION
To avoid possible injury, product, or property damage,
you will need two people to perform the following
instructions.
5