Viking Designer DDFB304 Installation Manual page 11

T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g
P P r r o o b b l l e e m m
Refrigerator has an odor
Water droplets form
outside of door
Water droplets form on
inside of refrigerator
Refrigerator or ice maker
makes unfamiliar sounds
or seems too loud
Temperature-controlled
drawers do not
close freely
Refrigerator runs too
frequently
I I c c e e a a n n d d W W a a t t e e r r
Ice maker is not
producing ice.
Water filter indicator
light is red
Refrigerator is leaking
water
* * M M a a n n u u f f a a c c t t u u r r e e r r i i s s n n o o t t r r e e s s p p o o n n s s i i b b l l e e f f o o r r p p r r o o p p e e r r t t y y d d a a m m a a g g e e d d u u e e t t o o i i m m p p r r o o p p e e r r i i n n s s t t a a l l l l a a t t i i o o n n o o r r w w a a t t e e r r c c o o n n n n e e c c t t i i o o n n . .
P P o o s s s s i i b b l l e e C C a a u u s s e e
Odor producing foods should be covered.
The interior needs cleaning.
Door gaskets are not sealing properly.
Humidity levels are high.
Controls require adjustment.
Humidity levels are high or door has
been opened frequently.
Normal operation
Contents of drawer or positioning of items
in compartments is obstructing drawer.
Drawer is not in proper position
Drawer channels are dirty
or need treatment.
Door has been opened frequently or
has been opened for long periods of time.
Humidity levels too high.
Food has recently been added.
Refrigerator is exposed to heat by
environment or appliances nearby.
Condenser coils are dirty.
Controls need to be adjusted.
Door is not closing properly.
Door gaskets are not sealing properly.
Ice maker arm is up
Water supply is not reaching water valve.
Copper tubing has kinks
Water pressure is too low
Check freezer temperature
Ice bin is not installed properly
Improper water valve was installed.
Water filter needs to be replaced.
Filter indicator sensor needs to be reset
Plastic tubing was used for water connection
Improper water valve installed
W W h h a a t t T T o o D D o o
Clean according to instructions in use and care
Clean gaskets according to instructions in use and care.
Hot, humid weather can increase condensation.
See use and care to adjust controls.
Reduce time door is open. Organize food items efficiently to
assure door is open for as short a time as possible.
See operating sounds.
Reposition food and containers to avoid interference with the
drawers.
See use and care instructions for proper placement.
Clean drawer channels with warm, soapy water. Rinse
dry thoroughly. Apply thin layer of petroleum jelly to drawer
channels.
Reduce time door is open. Organize food items efficiently to
assure door is open for shortest time.
Normal operation
Allow time for added food to reach refrigerator or freezer
temperature.
Evaluate refrigerator's environment. Refrigerator may need to
may need to be moved to run more efficiently.
Clean coils according to instructions in use and care.
See use and care manual to adjust controls.
Check for internal obstructions that are keeping door from
closing properly.
Refrigerator is not level. See installation instructions for details
on how to level your refrigerator. Check gaskets for proper seal,
clean if necessary.
See use and care manual for cleaning instructions.
Confirm ice maker arm is down. See Automatic Ice Maker
instructions in use and care
See Connecting the Water Supply instructions.
Turn off water supply and remove kinks. If kinks cannot be
removed, replace tubing.
Low water pressure must be between 35 to 100 pounds per
square inch to function properly. A minimum pressure of 35
pounds per square inches recommended for refrigerators with
water filters.
See Temperature Controls in use and care manual to adjust
controls. Freezer must be between 0
See Ice and Water instructions in use and care manual.
See Connecting the Water Supply instructions. Self-piercing and
3/16" saddle valves cause low water pressure and may clog the
line over time.*
If filter is not available, replace with bypass filter. See Water
Filter instructions in use and care manual.
See Filter Status Indicator Light in use and care manual.
The manufacturer recommends using copper tubing. Plastic
is less durable and can cause leakage*.
Check water connection procedure in installation instructions.
Self piercing and 3/16" saddle valves cause low water pressure
and may clog the line over time.*
11
- 2 F (-18 to -17 C)/
o o o o