Viking Designer DDFB304 Installation Manual page 12

T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g
P P r r o o b b l l e e m m
Ice forms in inlet
tube to ice maker
Water flow is slower than
normal
.
Dispenser water is not
cold
Water appears cloudy
Particles in water and/or
ice cubes
* * M M a a n n u u f f a a c c t t u u r r e e r r i i s s n n o o t t r r e e s s p p o o n n s s i i b b l l e e f f o o r r p p r r o o p p e e r r t t y y d d a a m m a a g g e e d d u u e e t t o o i i m m p p r r o o p p e e r r i i n n s s t t a a l l l l a a t t i i o o n n o o r r w w a a t t e e r r c c o o n n n n e e c c t t i i o o n n . .
P P o o s s s s i i b b l l e e C C a a u u s s e e
Water pressure is low
Improper water valve installed.
Copper tubing has kinks
Saddle valve is not open completely.
Freezer temperature is too high
Water pressure is low
Saddle valve is not open completely.
Improper water valve installed.
Copper tubing has kinks
Water filter needs to be changed
Refrigerator has been recently installed.
Water supply in holding tank has been used.
Air or bubbles in water.
Cabon dust from water filter cartridge
Concentration of minerals in water will
form particles when water becomes frozen
and melts.
W W h h a a t t T T o o D D o o
Water pressure must be between 35 - 100 pounds per square
inch. A minimum pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Check water connection procedure in installation instructions.
Self piercing and 3/16" saddle valves cause low water pressure
and may clog the line over time.*
Turn off water supply and remove kinks. If kinks cannot be
removed, replace tubing.
Open saddle valve completely.
Adjust freezer controls. Freezer is recommended to be
approximately 0 o F (-18
Water pressure must be between 35 - 100 pounds per square
inch. A minimum pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Open saddle valve completely.
Check water connection procedure in installation instructions.
Self piercing and 3/16" saddle valves cause low water pressure
and may clog the line over time.*
Turn off water supply and remove kinks. If kinks cannot be
removed, replace tubing.
Change water filter. See use and care manual.
Allow approximately 12 hours for water in holding tank to chill.
This is normal when first using the dispenser and will disappear
with use.
Initial water ejected through cartridge may contain harmless
carbon dust flushed from cartridge. Will disappear after first few
uses.
Particles are not harmful and naturally occur in water supplies.
12
o C)/