Before Calling Forservice; Service Numbers - Kenmore ELITE 911.49022 Use & Care Manual

BEFORE CALLING FORSERVICE
To save you time and money, before making a service call check the list below
for any problem you may feel you have with the performance of your oven. If
the problem is something you cannot fix, use the Consumer Service Numbers
located at the back of this manual. When making any calls, have the Model
No., Serial No., Repair Parts List, Use and Care Guide and the Date of
Purchase available.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
The display of your
control is flashing "F"
followed by a number
or letter.
You have a function
error code.
Touch the CLEAR/OFF
pad. Restart the oven,
If the function code
repeats, disconnect all
power to the oven for at
least 30 seconds and then
reconnect power. If the
function error code repeats
again, call for service.
Oven temperature
seems inaccurate,
Oven control calibration. See the temperature
adjustment instructions
following this section.
Oven will not
unlock.
Clean cycle is not
finished.
Oven temperature must
drop below the lock
temperature before the
door will unlock.
Oven light does
not work.
a.
b,
Light switch in off
position.
Oven light bulb
loose or burned out.
a. Check oven light
switch on the control
panel.
b. Check the oven
light bulb.
Oven did not clean
or results were poor.
a. Controls were not set a.
properly,
b. Clean cycle was b.
interrupted.
c. Oven was soiled
heavily.
C.
Check the self-cleaning
section of this manual.
The normal clean
cycle should last
4 hours, 20 minutes.
Heavy spillovers should
be removed before the
cycle is set. You can
also repeat the cycle.
Oven rack does not
slide easily.
Racks were left in
the oven during a
Wipe the racks down with
vegetable oil.
self-clean cycle.
34