Fahrenheit 28026 Manual page 3

t, high c
harging
ury!
Connect the USB charging cable (Type-C) to the
Do not
soldering iron (5 V -2 A). The indicator LEDs on the side
of the battery inform you about the charging process.
uching
The soldering iron cannot be used for soldering work
while charging! A full charge takes 2-3 hours. If the
turally
LED indicator is flashing, there is a problem with the
ice on
battery, stop charging and contact a specialist service.
always
B
attery
u must
The battery that ensures operation is a built-in,
never
non-replaceable, standard 18650 Li-ion, type with
terials.
protection.
nlight
s
zontal,
oldering tip
ver.
Different types of soldering tips can be used for
dering
different types of work. Before replacing, wait until the
me into
tip has completely cooled down in, then unscrew and
ve the
insert the required tip.
u
loves, sage
zkot a
To turn on the soldering iron, remove the soldering
iron from the holder, press and hold the power button
mental
for 1-2 seconds. It only takes ~25 seconds to heat
se the
up the tip to operating condition. The operation is
use in
indicated by a blue LED and a lamp that illuminates
, local
the work area. After use, long press the power button,
then turn off the power button, then put it back in the
perate
power holder. If you do not use the tip for soldering for
se the
10 minutes, turn off the device.
uids.
c
leaning
for its
heat the soldering tip, then wipe off the residue with a
of the
microfiber cloth or a damp sponge! Do not use solvents
ecially
such as gasoline, alcohol, etc. These can damage plastic
ersons
surfaces. Never submerge the device in water.
al and
ersons
w
aste management
es may
The product and packaging are made from valuable,
evice!
recyclable materials. Recycling materials reduces the
se the
amount of waste and protects the environment.
(Valid in the European Union and all other European
never
states that participate in selective collection)
iately!
According to the 2012/19/EU directives, electrical
waste and appliances cannot be thrown away as
household waste. Old appliances must be collected
e sure
in order to maximize the recycling of raw materials,
dering,
thereby reducing their impact on people's health and
good
the environment. The crossed-out bin symbol is on all
products for which separate collection is mandatory.
iquids
Consumers should check with their local authorities for
more information.
TOR
AGES
ROM
p
roperties
Performance
Battery type
Weight
Soldering iron length
(without tip)
Soldering iron cross
section
Soldering iron power
supply
28026
10 W
18650 Li-Ion, 4 V, 1500
maH), not replacable
Soldering iron: 130 g
Base: 135 g
180 mm
35 x 25 mm
4 V -2 A USB Type-C