Mounting The Front And Surround Speakers - Yamaha DVX-S60 Owner's Manual

Mounting the front and surround speakers
Mount the speakers on a shelf, rack or directly on the floor, or hang them
on the wail
To mount the speakers on a wall by using the holes on the speakers'
back panels
1. Fasten screws into a firm wall or wall support as shown in the figure,
Diam. 3.5-4 mm
Round head screw
(not supplied)
_
Min.
Wall/wall support 20 mm
2. Hang the speaker by mounting the holes on the protruding screws.
* Make surs that the scrsws are securely caught by the narrow parts
of the holes,
70 mm
Placing the the main/surround speakers
When placing the speakers on a flat surface, attach the included nonskid
pads to the corners on the bottom of the speakers, This prevents the
speakers from sliding around.
Nonskid pad
If you want to mount a speaker on a commercially available speaker
stand for the front/surround speakers
The provided mounting bracket with 1 pair of screw holes (at an interval
of 60 mm) can be used to mount the speaker on a speaker stand.
* Those screw holes can be used with M4 screws only.
60 mm
1. Attach the bracket to the bottom of the speaker by using the provided
screw so that the convex part of the bracket fits in the grooved part
on the bottom of the speaker,
WARNING
• Each speaker weighs 0.9 kg (2 Ibs.). Do not mount them on thin
plywood or a wall composed of a soft surface material.If mounted,
the screws may pull out of the flimsy surface and the speakers
may fall. This may damage the speakers or cause personal injury.
• Do not affix the speakers to a wall using nails, adhesives, or any
other unstable hardware. Long-term use and vibrations may cause
the speakers to fall.
• To avoid accidents resulting from tripping over loose speaker
cables, fix the cables to the wall.
• Select an appropriate position on the wall to mount the speaker
so that no one will injure his/her head or face.
Using theYamaha Speaker Stand SPS-8O (option)
By using the Yamaha Speaker Stand SPS-8O, speakers can be ptaced
on the floor.
Mounting
/
Screw
2. Mount the speaker on the speaker stand by using the screw holes on
the bracket.
Note:
The mounting bracket is provided for each speaker.
SPS-8O _
Note:
Be careful not to let the speaker system fall, it might cause damage
or serious injuries,
If you use the other speaker system, ptease refer to "Speaker"
under "SETTINGS ON THE SET UP MENU". (See Page 17.)
* The SPS-80 is not available in some areas.
E-7