Advertisement
Quick Links
Technical Support and E-Warranty Certificate www.vevor.com/support
Dog Gate
We continue to be committed to provide you tools with competitive price.
"Save Half", "Half Price" or any other similar expressions used by us only represents an
estimate of savings you might benefit from buying certain tools with us compared to the major
top brands and does not necessarily mean to cover all categories of tools offered by us. You
are kindly reminded to verify carefully when you are placing an order with us if you are
actually saving half in comparison with the top major brands.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for VEVOR W3312
Summary of Contents for VEVOR W3312
- Page 1 Technical Support and E-Warranty Certificate www.vevor.com/support Dog Gate We continue to be committed to provide you tools with competitive price. "Save Half", "Half Price" or any other similar expressions used by us only represents an estimate of savings you might benefit from buying certain tools with us compared to the major top brands and does not necessarily mean to cover all categories of tools offered by us.
- Page 2 This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won't inform you again if there are any technology or software updates on our product.
- Page 3 Thank you very much for choosing this dog gate . Please read all of the instructions before using it. The information will help you achieve the best possible results. Model and Parameters Model W3312 W3312 W3336 W3336 W3350 W3350 W3360 W3360 29.5”-39” 29.5”-48.4” 29.5”-53” 29.5”-57.8”...
-
Page 4: Product & Parts
Product & Parts - 3 -... -
Page 5: Maintenance
MAINTENANCE Clean by using a sponge with warm water or mild detergent. DO NOT use abrasive cleaners or bleach. Check the gate regularly to ensure all hardware and mounts are securely tightened. Do NOT use if any component is damaged or missing. STEP 1. - Page 6 STEP 2. Insert 4 bolts into 4 corners of the gate/extension. STEP 3. Pre-assemble the gate, and locate four points for hole drilling. Hold the wall cup in position and mark the center with a pencil. - 5 -...
- Page 7 PLEASE NOTE: The gate should be resting on the floor. DO NOT allow a gap of more than 0.5cm between the gate and the floor. STEP 4. Stick the pad when using pressure mounted installation. Remove two sides of the sticky pad, stick 4 pads to 4 wall cups. Then wall cups cover the bolts.
- Page 8 STEP 5. Drill hole for the 4 marked positions, then put dry wall anchor(g)and use screw(f)and the wall cup (d) STEP 6. Tighten the top of the tension knobs by turning them clockwise at the same time Note: Make sure the bottom of the gate frame remains completely flat on the floor. Next, tighten the bottom of the tension knobs at the top at the same time by turning them clockwise.
- Page 9 2.Pay attention to adjusting the left and right clearance to ensure that the left and right clearance is consistent. STEP 7. Cut off the belt and test the gate: 1.Push the gate to check stability. 2.Open and close the walk through gate. Pull the button to the right, then lift the gate panel UP to open.
-
Page 10: Trouble Shoting
·You MUST install [wall cups] to keep the gate in place. Without [wall cups], the child can push out and escape. ·NEVER use it to keep the child away from a pool. ·Thanks for purchasing VEVOR product! - 9 -... - Page 11 Address: Baoshanqu Shuangchenglu 803long 11hao 1602A-1609shi Shanghai EC REP: SHUNSHUN GmbH. Römeräcker 9 Z2021,76351 Linkenheim-Hochstetten, Germany UK REP： Pooledas Group Ltd. Unit 5 Albert Edward House, The Pavilions Preston, United Kingdom Imported to AUS: SIHAO PTY LTD. 1 ROKEVA STREETEASTWOOD NSW 2122 Australia Imported to USA: Sanven Technology Ltd.
- Page 12 Technical Support and E-Warranty Certificate www.vevor.com/support...
Need help?
Do you have a question about the W3312 and is the answer not in the manual?
Questions and answers